Commit aa211d20 authored by Javier Martinez Canillas's avatar Javier Martinez Canillas Committed by David S. Miller

3c59x: use IS_ENABLED() instead of checking for built-in or module

The IS_ENABLED() macro checks if a Kconfig symbol has been enabled either
built-in or as a module, use that macro instead of open coding the same.

Using the macro makes the code more readable by helping abstract away some
of the Kconfig built-in and module enable details.
Signed-off-by: default avatarJavier Martinez Canillas <javier@osg.samsung.com>
Signed-off-by: default avatarDavid S. Miller <davem@davemloft.net>
parent b20b378d
...@@ -3089,7 +3089,7 @@ static void set_rx_mode(struct net_device *dev) ...@@ -3089,7 +3089,7 @@ static void set_rx_mode(struct net_device *dev)
iowrite16(new_mode, ioaddr + EL3_CMD); iowrite16(new_mode, ioaddr + EL3_CMD);
} }
#if defined(CONFIG_VLAN_8021Q) || defined(CONFIG_VLAN_8021Q_MODULE) #if IS_ENABLED(CONFIG_VLAN_8021Q)
/* Setup the card so that it can receive frames with an 802.1q VLAN tag. /* Setup the card so that it can receive frames with an 802.1q VLAN tag.
Note that this must be done after each RxReset due to some backwards Note that this must be done after each RxReset due to some backwards
compatibility logic in the Cyclone and Tornado ASICs */ compatibility logic in the Cyclone and Tornado ASICs */
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment