Commit aa298b55 authored by Jakub Kicinski's avatar Jakub Kicinski

Merge branch 'fix-rgmii-delays-for-88e1118'

Russell King says:

====================
Fix RGMII delays for 88E1118

This series fixes the RGMII delays for 88E1118 Marvell PHYs, after
a report by Corentin Labbe that the Marvell driver fails to work.

Patch 1 cleans up the paged register accesses in m88e1118_config_init()
and patch 2 adds the RGMII delay configuration.

This comes with an element of risk as existing DT may need to be fixed
for this in a similar way as we have done in the recent past for other
PHY drivers that have misinterpreted the RGMII interface modes.
====================

Link: https://lore.kernel.org/r/YdR3wYFkm4eJApwb@shell.armlinux.org.ukSigned-off-by: default avatarJakub Kicinski <kuba@kernel.org>
parents 2d6ec255 f22725c9
......@@ -1225,28 +1225,28 @@ static int m88e1118_config_aneg(struct phy_device *phydev)
static int m88e1118_config_init(struct phy_device *phydev)
{
u16 leds;
int err;
/* Change address */
err = marvell_set_page(phydev, MII_MARVELL_MSCR_PAGE);
if (err < 0)
return err;
/* Enable 1000 Mbit */
err = phy_write(phydev, 0x15, 0x1070);
err = phy_write_paged(phydev, MII_MARVELL_MSCR_PAGE,
MII_88E1121_PHY_MSCR_REG, 0x1070);
if (err < 0)
return err;
/* Change address */
err = marvell_set_page(phydev, MII_MARVELL_LED_PAGE);
if (err < 0)
return err;
if (phy_interface_is_rgmii(phydev)) {
err = m88e1121_config_aneg_rgmii_delays(phydev);
if (err < 0)
return err;
}
/* Adjust LED Control */
if (phydev->dev_flags & MARVELL_PHY_M1118_DNS323_LEDS)
err = phy_write(phydev, 0x10, 0x1100);
leds = 0x1100;
else
err = phy_write(phydev, 0x10, 0x021e);
leds = 0x021e;
err = phy_write_paged(phydev, MII_MARVELL_LED_PAGE, 0x10, leds);
if (err < 0)
return err;
......@@ -1254,7 +1254,7 @@ static int m88e1118_config_init(struct phy_device *phydev)
if (err < 0)
return err;
/* Reset address */
/* Reset page register */
err = marvell_set_page(phydev, MII_MARVELL_COPPER_PAGE);
if (err < 0)
return err;
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment