Commit aace95b8 authored by Ebru Akagunduz's avatar Ebru Akagunduz Committed by Greg Kroah-Hartman

Staging: rtl8187se: fix please, no space before tabs in r8185b_init.c

Fix checkpatch.pl issues with please, no space before
tabs in r8185b_init.c
Signed-off-by: default avatarEbru Akagunduz <ebru.akagunduz@gmail.com>
Signed-off-by: default avatarGreg Kroah-Hartman <gregkh@linuxfoundation.org>
parent 8787fcd2
...@@ -487,13 +487,13 @@ static void ZEBRA_Config_85BASIC_HardCode(struct net_device *dev) ...@@ -487,13 +487,13 @@ static void ZEBRA_Config_85BASIC_HardCode(struct net_device *dev)
/* For crystal calibration, added by Roger, 2007.12.11. */ /* For crystal calibration, added by Roger, 2007.12.11. */
if (priv->bXtalCalibration) { /* reg 30. */ if (priv->bXtalCalibration) { /* reg 30. */
/* /*
* enable crystal calibration. * enable crystal calibration.
* RF Reg[30], (1)Xin:[12:9], Xout:[8:5], addr[4:0]. * RF Reg[30], (1)Xin:[12:9], Xout:[8:5], addr[4:0].
* (2)PA Pwr delay timer[15:14], default: 2.4us, * (2)PA Pwr delay timer[15:14], default: 2.4us,
* set BIT15=0 * set BIT15=0
* (3)RF signal on/off when calibration[13], default: on, * (3)RF signal on/off when calibration[13], default: on,
* set BIT13=0. * set BIT13=0.
* So we should minus 4 BITs offset. * So we should minus 4 BITs offset.
*/ */
RF_WriteReg(dev, 0x0f, (priv->XtalCal_Xin<<5) | RF_WriteReg(dev, 0x0f, (priv->XtalCal_Xin<<5) |
(priv->XtalCal_Xout<<1) | BIT11 | BIT9); mdelay(1); (priv->XtalCal_Xout<<1) | BIT11 | BIT9); mdelay(1);
...@@ -953,10 +953,10 @@ static void ActSetWirelessMode8185(struct net_device *dev, u8 btWirelessMode) ...@@ -953,10 +953,10 @@ static void ActSetWirelessMode8185(struct net_device *dev, u8 btWirelessMode)
} }
/* /*
* 2. Swtich band: RF or BB specific actions, * 2. Swtich band: RF or BB specific actions,
* for example, refresh tables in omc8255, or change initial gain if * for example, refresh tables in omc8255, or change initial gain if
* necessary. Nothing to do for Zebra to switch band. Update current * necessary. Nothing to do for Zebra to switch band. Update current
* wireless mode if we switch to specified band successfully. * wireless mode if we switch to specified band successfully.
*/ */
ieee->mode = (WIRELESS_MODE)btWirelessMode; ieee->mode = (WIRELESS_MODE)btWirelessMode;
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment