video: ssd1307fb: Do not hard code active-low reset sequence

The SSD130x OLED display reset signal is active low. Now the reset
sequence is implemented in such a way that users are forced to
define reset-gpios as GPIO_ACTIVE_HIGH in DT to make the reset work.

Do not hard code the active-low sequence into the driver but instead
allow the user to specify the gpio as GPIO_ACTIVE_LOW to reflect
the real world.
Reviewed-by: Rob Herring <robh@kernel.org>
Reviewed-by: Alexandre Belloni <alexandre.belloni@bootlin.com>
Cc: Shawn Guo <shawnguo@kernel.org>
Cc: Fabio Estevam <fabio.estevam@nxp.com>
Cc: Maxime Ripard <maxime.ripard@bootlin.com>,
Signed-off-by: Michal Vokáč <michal.vokac@ysoft.com>
Signed-off-by: Bartlomiej Zolnierkiewicz <b.zolnierkie@samsung.com>

drivers/video/fbdev/ssd1307fb.c

@@ -667,10 +667,10 @@ static int ssd1307fb_probe(struct i2c_client *client,
 
 	if (par->reset) {
 		/* Reset the screen */
-		gpiod_set_value_cansleep(par->reset, 0);
-		udelay(4);
 		gpiod_set_value_cansleep(par->reset, 1);
 		udelay(4);
+		gpiod_set_value_cansleep(par->reset, 0);
+		udelay(4);
 	}
 
 	if (par->vbat_reg) {