Revert "usb: dwc3: don't reset device side if dwc3 was configured as host-only"

This reverts commit e835c0a4.

Don't omit soft-reset. During initialization, the driver may need to
perform a soft reset to ensure the phy is ready when the controller
updates the GCTL.PRTCAPDIR or other settings by issuing phy soft-reset.
Many platforms often have access to DCTL register for soft-reset despite
being host-only. If there are actual reported issues from the platforms
that don't expose DCTL registers, then we will need to revisit (perhaps
to teach dwc3 to perform xhci's soft-reset USBCMD.HCRST).

Cc:  <stable@vger.kernel.org>
Fixes: e835c0a4 ("usb: dwc3: don't reset device side if dwc3 was configured as host-only")
Signed-off-by: Thinh Nguyen <Thinh.Nguyen@synopsys.com>
Link: https://lore.kernel.org/r/7668ab11a48f260820825274976eb41fec7f54d1.1703282469.git.Thinh.Nguyen@synopsys.comSigned-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

drivers/usb/dwc3/core.c

@@ -277,9 +277,9 @@ int dwc3_core_soft_reset(struct dwc3 *dwc)
 	/*
 	 * We're resetting only the device side because, if we're in host mode,
 	 * XHCI driver will reset the host block. If dwc3 was configured for
-	 * host-only mode or current role is host, then we can return early.
+	 * host-only mode, then we can return early.
 	 */
-	if (dwc->dr_mode == USB_DR_MODE_HOST || dwc->current_dr_role == DWC3_GCTL_PRTCAP_HOST)
+	if (dwc->current_dr_role == DWC3_GCTL_PRTCAP_HOST)
 		return 0;
 
 	reg = dwc3_readl(dwc->regs, DWC3_DCTL);