Commit b453ff84 authored by Sreekanth Reddy's avatar Sreekanth Reddy Committed by James Bottomley

[SCSI] mpt3sas: Updated the Hardware timing requirements

Hardware timing requirements is updated in order to comply with firmware
requirement.
Signed-off-by: default avatarSreekanth Reddy <Sreekanth.Reddy@lsi.com>
Signed-off-by: default avatarJames Bottomley <JBottomley@Parallels.com>
parent 48e3b985
......@@ -4090,11 +4090,15 @@ _base_diag_reset(struct MPT3SAS_ADAPTER *ioc, int sleep_flag)
writel(host_diagnostic | MPI2_DIAG_RESET_ADAPTER,
&ioc->chip->HostDiagnostic);
/* don't access any registers for 50 milliseconds */
msleep(50);
/*This delay allows the chip PCIe hardware time to finish reset tasks*/
if (sleep_flag == CAN_SLEEP)
msleep(MPI2_HARD_RESET_PCIE_FIRST_READ_DELAY_MICRO_SEC/1000);
else
mdelay(MPI2_HARD_RESET_PCIE_FIRST_READ_DELAY_MICRO_SEC/1000);
/* 300 second max wait */
for (count = 0; count < 3000000 ; count++) {
/* Approximately 300 second max wait */
for (count = 0; count < (300000000 /
MPI2_HARD_RESET_PCIE_SECOND_READ_DELAY_MICRO_SEC); count++) {
host_diagnostic = readl(&ioc->chip->HostDiagnostic);
......@@ -4103,11 +4107,13 @@ _base_diag_reset(struct MPT3SAS_ADAPTER *ioc, int sleep_flag)
if (!(host_diagnostic & MPI2_DIAG_RESET_ADAPTER))
break;
/* wait 1 msec */
/* Wait to pass the second read delay window */
if (sleep_flag == CAN_SLEEP)
usleep_range(1000, 1500);
msleep(MPI2_HARD_RESET_PCIE_SECOND_READ_DELAY_MICRO_SEC
/ 1000);
else
mdelay(1);
mdelay(MPI2_HARD_RESET_PCIE_SECOND_READ_DELAY_MICRO_SEC
/ 1000);
}
if (host_diagnostic & MPI2_DIAG_HCB_MODE) {
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment