[POWERPC] 4xx: Only reset PCIe PHY on 405EX systems when no link is detected

Since the arch/powerpc PCI subsystem now does a complete re-assignment of
the resources, we can move from the unconditional PCIe PHY reset to the
conditional version. Now the PHY is only reset, if no link is established yet.
An additional PHY reset (one is already done in U-Boot) leads to problems
with some Atheros PCIe boards and some HP FPGA PCIe designs.
Signed-off-by: Stefan Roese <sr@denx.de>
Signed-off-by: Josh Boyer <jwboyer@linux.vnet.ibm.com>

arch/powerpc/sysdev/ppc4xx_pci.c

@@ -940,17 +940,9 @@ static int ppc405ex_pciex_init_port_hw(struct ppc4xx_pciex_port *port)
 	 * PCIe boards don't show this problem.
 	 * This has to be re-tested and fixed in a later release!
 	 */
-#if 0 /* XXX FIXME: Not resetting the PHY will leave all resources
-       * configured as done previously by U-Boot. Then Linux will currently
-       * not reassign them. So the PHY reset is now done always. This will
-       * lead to problems with the Atheros PCIe board again.
-       */
 	val = mfdcri(SDR0, port->sdr_base + PESDRn_LOOP);
 	if (!(val & 0x00001000))
 		ppc405ex_pcie_phy_reset(port);
-#else
-	ppc405ex_pcie_phy_reset(port);
-#endif
 
 	dcr_write(port->dcrs, DCRO_PEGPL_CFG, 0x10000000);  /* guarded on */