Commit b6f6c294 authored by Mauro Carvalho Chehab's avatar Mauro Carvalho Chehab

mtd: adjust kernel-docs to avoid Sphinx/kerneldoc warnings

./drivers/mtd/nand/nand_bbt.c:1: warning: no structured comments found
./include/linux/mtd/nand.h:785: ERROR: Unexpected indentation.
./drivers/mtd/nand/nand_base.c:449: WARNING: Definition list ends without a blank line; unexpected unindent.
./drivers/mtd/nand/nand_base.c:1161: ERROR: Unexpected indentation.
./drivers/mtd/nand/nand_base.c:1162: WARNING: Block quote ends without a blank line; unexpected unindent.
Signed-off-by: default avatarMauro Carvalho Chehab <mchehab@s-opensource.com>
parent f341afe2
......@@ -970,9 +970,6 @@ hints" for an explanation.
.. kernel-doc:: drivers/mtd/nand/nand_base.c
:export:
.. kernel-doc:: drivers/mtd/nand/nand_bbt.c
:export:
.. kernel-doc:: drivers/mtd/nand/nand_ecc.c
:export:
......
......@@ -442,10 +442,12 @@ static int nand_default_block_markbad(struct mtd_info *mtd, loff_t ofs)
* specify how to write bad block markers to OOB (chip->block_markbad).
*
* We try operations in the following order:
*
* (1) erase the affected block, to allow OOB marker to be written cleanly
* (2) write bad block marker to OOB area of affected block (unless flag
* NAND_BBT_NO_OOB_BBM is present)
* (3) update the BBT
*
* Note that we retain the first error encountered in (2) or (3), finish the
* procedures, and dump the error in the end.
*/
......@@ -1155,9 +1157,10 @@ int nand_reset(struct nand_chip *chip, int chipnr)
* @mtd: mtd info
* @ofs: offset to start unlock from
* @len: length to unlock
* @invert: when = 0, unlock the range of blocks within the lower and
* @invert:
* - when = 0, unlock the range of blocks within the lower and
* upper boundary address
* when = 1, unlock the range of blocks outside the boundaries
* - when = 1, unlock the range of blocks outside the boundaries
* of the lower and upper boundary address
*
* Returs unlock status.
......
......@@ -779,7 +779,7 @@ nand_get_sdr_timings(const struct nand_data_interface *conf)
* Minimum amount of bit errors per @ecc_step_ds guaranteed
* to be correctable. If unknown, set to zero.
* @ecc_step_ds: [INTERN] ECC step required by the @ecc_strength_ds,
* also from the datasheet. It is the recommended ECC step
* also from the datasheet. It is the recommended ECC step
* size, if known; if unknown, set to zero.
* @onfi_timing_mode_default: [INTERN] default ONFI timing mode. This field is
* set to the actually used ONFI mode if the chip is
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment