arm64: dts: allwinner: sun50i-a64: Use macros for newly exported clocks

A few clocks from the CCU were exported later, and references to them in
the device tree were using raw numbers.

Now that the DT binding header changes are in as well, switch to the
macros for more clarity.
Signed-off-by: Chen-Yu Tsai <wens@csie.org>
Signed-off-by: Maxime Ripard <maxime@cerno.tech>

arch/arm64/boot/dts/allwinner/sun50i-a64.dtsi

@@ -590,7 +590,7 @@ pio: pinctrl@1c20800 {
 			interrupts = <GIC_SPI 11 IRQ_TYPE_LEVEL_HIGH>,
 				     <GIC_SPI 17 IRQ_TYPE_LEVEL_HIGH>,
 				     <GIC_SPI 21 IRQ_TYPE_LEVEL_HIGH>;
-			clocks = <&ccu 58>, <&osc24M>, <&rtc 0>;
+			clocks = <&ccu CLK_BUS_PIO>, <&osc24M>, <&rtc 0>;
 			clock-names = "apb", "hosc", "losc";
 			gpio-controller;
 			#gpio-cells = <3>;
@@ -1091,7 +1091,7 @@ hdmi_phy: hdmi-phy@1ef0000 {
 			compatible = "allwinner,sun50i-a64-hdmi-phy";
 			reg = <0x01ef0000 0x10000>;
 			clocks = <&ccu CLK_BUS_HDMI>, <&ccu CLK_HDMI_DDC>,
-				 <&ccu 7>;
+				 <&ccu CLK_PLL_VIDEO0>;
 			clock-names = "bus", "mod", "pll-0";
 			resets = <&ccu RST_BUS_HDMI0>;
 			reset-names = "phy";
@@ -1121,7 +1121,8 @@ r_intc: interrupt-controller@1f00c00 {
 		r_ccu: clock@1f01400 {
 			compatible = "allwinner,sun50i-a64-r-ccu";
 			reg = <0x01f01400 0x100>;
-			clocks = <&osc24M>, <&rtc 0>, <&rtc 2>, <&ccu 11>;
+			clocks = <&osc24M>, <&rtc 0>, <&rtc 2>,
+				 <&ccu CLK_PLL_PERIPH0>;
 			clock-names = "hosc", "losc", "iosc", "pll-periph";
 			#clock-cells = <1>;
 			#reset-cells = <1>;