[SCSI] qla2xxx: Correct descriptions in flash manipulation routines.

When clearing the flash device's SR, the comment is incorrect...
clearing the SR is 2 steps:

1. the SR protect bit is 1, so the first write zero clears only
   that bit,

2. the SR protect bit is now 0, so the next write zero clears the
   remaining bits.

The sector erase debug print more correctly identifies that the erase failed.
Signed-off-by: Andrew Vasquez <andrew.vasquez@qlogic.com>
Signed-off-by: James Bottomley <James.Bottomley@HansenPartnership.com>

drivers/scsi/qla2xxx/qla_sup.c

@@ -944,9 +944,9 @@ qla24xx_unprotect_flash(struct qla_hw_data *ha)
 	if (!ha->fdt_wrt_disable)
 		return;
 
-	/* Disable flash write-protection. */
+	/* Disable flash write-protection, first clear SR protection bit */
 	qla24xx_write_flash_dword(ha, flash_conf_addr(ha, 0x101), 0);
-	/* Some flash parts need an additional zero-write to clear bits.*/
+	/* Then write zero again to clear remaining SR bits.*/
 	qla24xx_write_flash_dword(ha, flash_conf_addr(ha, 0x101), 0);
 }
 
@@ -1021,7 +1021,7 @@ qla24xx_write_flash_data(scsi_qla_host_t *vha, uint32_t *dwptr, uint32_t faddr,
 			    (fdata & 0xff00) |((fdata << 16) &
 			    0xff0000) | ((fdata >> 16) & 0xff));
 			if (ret != QLA_SUCCESS) {
-				DEBUG9(qla_printk("Unable to flash sector: "
+				DEBUG9(qla_printk("Unable to erase sector: "
 				    "address=%x.\n", faddr));
 				break;
 			}