Commit b99a212a authored by Tony Lindgren's avatar Tony Lindgren Committed by Daniel Lezcano

clocksource/drivers/timer-ti-dm: Fix make W=n kerneldoc warnings

Kernel test robot reports of kerneldoc related warnings that happen with
make W=n for "parameter or member not described".

These were caused by changes to function parameter names with
earlier commits where the kerneldoc parts were not updated.

Fixes: 49cd16bb ("clocksource/drivers/timer-ti-dm: Simplify register writes with dmtimer_write()")
Fixes: a6e543f6 ("clocksource/drivers/timer-ti-dm: Move struct omap_dm_timer fields to driver")
Reported-by: default avatarkernel test robot <lkp@intel.com>
Closes: https://lore.kernel.org/oe-kbuild-all/202311040403.DzIiBuwU-lkp@intel.com/
Closes: https://lore.kernel.org/oe-kbuild-all/202311040606.XL5OcR9O-lkp@intel.com/Signed-off-by: default avatarTony Lindgren <tony@atomide.com>
Reviewed-by: default avatarRandy Dunlap <rdunlap@infradead.org>
Tested-by: default avatarRandy Dunlap <rdunlap@infradead.org>
Signed-off-by: default avatarDaniel Lezcano <daniel.lezcano@linaro.org>
Link: https://lore.kernel.org/r/20231114072930.40615-1-tony@atomide.com
parent 6a902b11
......@@ -183,7 +183,7 @@ static inline u32 dmtimer_read(struct dmtimer *timer, u32 reg)
* dmtimer_write - write timer registers in posted and non-posted mode
* @timer: timer pointer over which write operation is to perform
* @reg: lowest byte holds the register offset
* @value: data to write into the register
* @val: data to write into the register
*
* The posted mode bit is encoded in reg. Note that in posted mode, the write
* pending bit must be checked. Otherwise a write on a register which has a
......@@ -949,7 +949,7 @@ static int omap_dm_timer_set_int_enable(struct omap_dm_timer *cookie,
/**
* omap_dm_timer_set_int_disable - disable timer interrupts
* @timer: pointer to timer handle
* @cookie: pointer to timer cookie
* @mask: bit mask of interrupts to be disabled
*
* Disables the specified timer interrupts for a timer.
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment