wifi: ath11k: Add coldboot calibration support for QCN9074

QCN9074 supports 6 GHz, which has increased number of channels
compared to 5 GHz/2 GHz. So, to support coldboot calibration in
QCN9074 ATH11K_COLD_BOOT_FW_RESET_DELAY extended to 60 seconds. To
avoid code redundancy, fwreset_from_cold_boot moved to QMI and made
common for both ahb and pci. Coldboot calibration is enabled only in
FTM mode for QCN9074. QCN9074 requires firmware restart after coldboot,
hence enable cbcal_restart_fw in hw_params.

This support can be enabled/disabled using hw params for different
hardware. Currently it is not enabled for QCA6390.

Tested-on: QCN9074 hw1.0 PCI WLAN.HK.2.7.0.1-01744-QCAHKSWPL_SILICONZ-1
Signed-off-by: Anilkumar Kolli <quic_akolli@quicinc.com>
Signed-off-by: Seevalamuthu Mariappan <quic_seevalam@quicinc.com>
Signed-off-by: Raj Kumar Bhagat <quic_rajkbhag@quicinc.com>
Signed-off-by: Kalle Valo <quic_kvalo@quicinc.com>
Link: https://lore.kernel.org/r/20230726141032.3061-3-quic_rajkbhag@quicinc.com

drivers/net/wireless/ath/ath11k/ahb.c

@@ -14,6 +14,7 @@
 #include "ahb.h"
 #include "debug.h"
 #include "hif.h"
+#include "qmi.h"
 #include <linux/remoteproc.h>
 #include "pcic.h"
 #include <linux/soc/qcom/smem.h>
@@ -419,31 +420,6 @@ static void ath11k_ahb_power_down(struct ath11k_base *ab)
 	rproc_shutdown(ab_ahb->tgt_rproc);
 }
 
-static int ath11k_ahb_fwreset_from_cold_boot(struct ath11k_base *ab)
-{
-	int timeout;
-
-	if (!ath11k_core_coldboot_cal_support(ab) || ab->qmi.cal_done ||
-	    ab->hw_params.cbcal_restart_fw == 0)
-		return 0;
-
-	ath11k_dbg(ab, ATH11K_DBG_AHB, "wait for cold boot done\n");
-	timeout = wait_event_timeout(ab->qmi.cold_boot_waitq,
-				     (ab->qmi.cal_done  == 1),
-				     ATH11K_COLD_BOOT_FW_RESET_DELAY);
-	if (timeout <= 0) {
-		ath11k_cold_boot_cal = 0;
-		ath11k_warn(ab, "Coldboot Calibration failed timed out\n");
-	}
-
-	/* reset the firmware */
-	ath11k_ahb_power_down(ab);
-	ath11k_ahb_power_up(ab);
-
-	ath11k_dbg(ab, ATH11K_DBG_AHB, "exited from cold boot mode\n");
-	return 0;
-}
-
 static void ath11k_ahb_init_qmi_ce_config(struct ath11k_base *ab)
 {
 	struct ath11k_qmi_ce_cfg *cfg = &ab->qmi.ce_cfg;
@@ -1226,7 +1202,7 @@ static int ath11k_ahb_probe(struct platform_device *pdev)
 		goto err_ce_free;
 	}
 
-	ath11k_ahb_fwreset_from_cold_boot(ab);
+	ath11k_qmi_fwreset_from_cold_boot(ab);
 
 	return 0;
 

drivers/net/wireless/ath/ath11k/core.c

@@ -336,8 +336,8 @@ static const struct ath11k_hw_params ath11k_hw_params[] = {
 		.idle_ps = false,
 		.supports_sta_ps = false,
 		.coldboot_cal_mm = false,
-		.coldboot_cal_ftm = false,
-		.cbcal_restart_fw = false,
+		.coldboot_cal_ftm = true,
+		.cbcal_restart_fw = true,
 		.fw_mem_mode = 2,
 		.num_vdevs = 8,
 		.num_peers = 128,

drivers/net/wireless/ath/ath11k/pci.c

@@ -15,6 +15,7 @@
 #include "mhi.h"
 #include "debug.h"
 #include "pcic.h"
+#include "qmi.h"
 
 #define ATH11K_PCI_BAR_NUM		0
 #define ATH11K_PCI_DMA_MASK		32
@@ -897,6 +898,7 @@ static int ath11k_pci_probe(struct pci_dev *pdev,
 		ath11k_err(ab, "failed to init core: %d\n", ret);
 		goto err_irq_affinity_cleanup;
 	}
+	ath11k_qmi_fwreset_from_cold_boot(ab);
 	return 0;
 
 err_irq_affinity_cleanup:

drivers/net/wireless/ath/ath11k/qmi.c

@@ -9,6 +9,7 @@
 #include "qmi.h"
 #include "core.h"
 #include "debug.h"
+#include "hif.h"
 #include <linux/of.h>
 #include <linux/of_address.h>
 #include <linux/ioport.h>
@@ -2839,6 +2840,33 @@ int ath11k_qmi_firmware_start(struct ath11k_base *ab,
 	return 0;
 }
 
+int ath11k_qmi_fwreset_from_cold_boot(struct ath11k_base *ab)
+{
+	int timeout;
+
+	if (!ath11k_core_coldboot_cal_support(ab) || ab->qmi.cal_done ||
+	    ab->hw_params.cbcal_restart_fw == 0)
+		return 0;
+
+	ath11k_dbg(ab, ATH11K_DBG_QMI, "wait for cold boot done\n");
+
+	timeout = wait_event_timeout(ab->qmi.cold_boot_waitq,
+				     (ab->qmi.cal_done == 1),
+				     ATH11K_COLD_BOOT_FW_RESET_DELAY);
+
+	if (timeout <= 0) {
+		ath11k_warn(ab, "Coldboot Calibration timed out\n");
+		return -ETIMEDOUT;
+	}
+
+	/* reset the firmware */
+	ath11k_hif_power_down(ab);
+	ath11k_hif_power_up(ab);
+	ath11k_dbg(ab, ATH11K_DBG_QMI, "exit wait for cold boot done\n");
+	return 0;
+}
+EXPORT_SYMBOL(ath11k_qmi_fwreset_from_cold_boot);
+
 static int ath11k_qmi_process_coldboot_calibration(struct ath11k_base *ab)
 {
 	int timeout;

drivers/net/wireless/ath/ath11k/qmi.h

@@ -37,7 +37,7 @@
 
 #define QMI_WLANFW_MAX_DATA_SIZE_V01		6144
 #define ATH11K_FIRMWARE_MODE_OFF		4
-#define ATH11K_COLD_BOOT_FW_RESET_DELAY		(40 * HZ)
+#define ATH11K_COLD_BOOT_FW_RESET_DELAY		(60 * HZ)
 
 #define ATH11K_QMI_DEVICE_BAR_SIZE		0x200000
 
@@ -519,5 +519,6 @@ void ath11k_qmi_msg_recv_work(struct work_struct *work);
 void ath11k_qmi_deinit_service(struct ath11k_base *ab);
 int ath11k_qmi_init_service(struct ath11k_base *ab);
 void ath11k_qmi_free_resource(struct ath11k_base *ab);
+int ath11k_qmi_fwreset_from_cold_boot(struct ath11k_base *ab);
 
 #endif