Commit be91c362 authored by Yakir Yang's avatar Yakir Yang

dt-bindings: add document for rockchip variant of analogix_dp

Rockchip DP driver is a helper driver of analogix_dp coder driver,
so most of the DT property should be descriped in analogix_dp document.
Acked-by: default avatarRob Herring <robh@kernel.org>
Reviewed-by: default avatarHeiko Stuebner <heiko@sntech.de>
Signed-off-by: default avatarYakir Yang <ykk@rock-chips.com>
parent 9e32e16e
Rockchip RK3288 specific extensions to the Analogix Display Port
================================
Required properties:
- compatible: "rockchip,rk3288-edp";
- reg: physical base address of the controller and length
- clocks: from common clock binding: handle to dp clock.
of memory mapped region.
- clock-names: from common clock binding:
Required elements: "dp" "pclk"
- resets: Must contain an entry for each entry in reset-names.
See ../reset/reset.txt for details.
- pinctrl-names: Names corresponding to the chip hotplug pinctrl states.
- pinctrl-0: pin-control mode. should be <&edp_hpd>
- reset-names: Must include the name "dp"
- rockchip,grf: this soc should set GRF regs, so need get grf here.
- ports: there are 2 port nodes with endpoint definitions as defined in
Documentation/devicetree/bindings/media/video-interfaces.txt.
Port 0: contained 2 endpoints, connecting to the output of vop.
Port 1: contained 1 endpoint, connecting to the input of panel.
For the below properties, please refer to Analogix DP binding document:
* Documentation/devicetree/bindings/drm/bridge/analogix_dp.txt
- phys (required)
- phy-names (required)
- hpd-gpios (optional)
-------------------------------------------------------------------------------
Example:
dp-controller: dp@ff970000 {
compatible = "rockchip,rk3288-dp";
reg = <0xff970000 0x4000>;
interrupts = <GIC_SPI 98 IRQ_TYPE_LEVEL_HIGH>;
clocks = <&cru SCLK_EDP>, <&cru PCLK_EDP_CTRL>;
clock-names = "dp", "pclk";
phys = <&dp_phy>;
phy-names = "dp";
rockchip,grf = <&grf>;
resets = <&cru 111>;
reset-names = "dp";
pinctrl-names = "default";
pinctrl-0 = <&edp_hpd>;
status = "disabled";
ports {
#address-cells = <1>;
#size-cells = <0>;
edp_in: port@0 {
reg = <0>;
#address-cells = <1>;
#size-cells = <0>;
edp_in_vopb: endpoint@0 {
reg = <0>;
remote-endpoint = <&vopb_out_edp>;
};
edp_in_vopl: endpoint@1 {
reg = <1>;
remote-endpoint = <&vopl_out_edp>;
};
};
edp_out: port@1 {
reg = <1>;
#address-cells = <1>;
#size-cells = <0>;
edp_out_panel: endpoint {
reg = <0>;
remote-endpoint = <&panel_in_edp>
};
};
};
};
pinctrl {
edp {
edp_hpd: edp-hpd {
rockchip,pins = <7 11 RK_FUNC_2 &pcfg_pull_none>;
};
};
};
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment