spi: pxa2xx: Utilize struct device from struct ssp_device

We have a duplication of struct device in the struct driver_data,
get rid of it and reuse member from struct ssp_device instead.
Signed-off-by: Andy Shevchenko <andriy.shevchenko@linux.intel.com>
Link: https://lore.kernel.org/r/20210423182441.50272-4-andriy.shevchenko@linux.intel.comSigned-off-by: Mark Brown <broonie@kernel.org>

drivers/spi/spi-pxa2xx-dma.c

@@ -111,7 +111,7 @@ pxa2xx_spi_dma_prepare_one(struct driver_data *drv_data,
 
 	ret = dmaengine_slave_config(chan, &cfg);
 	if (ret) {
-		dev_warn(&drv_data->pdev->dev, "DMA slave config failed\n");
+		dev_warn(drv_data->ssp->dev, "DMA slave config failed\n");
 		return NULL;
 	}
 
@@ -125,7 +125,7 @@ irqreturn_t pxa2xx_spi_dma_transfer(struct driver_data *drv_data)
 
 	status = pxa2xx_spi_read(drv_data, SSSR) & drv_data->mask_sr;
 	if (status & SSSR_ROR) {
-		dev_err(&drv_data->pdev->dev, "FIFO overrun\n");
+		dev_err(drv_data->ssp->dev, "FIFO overrun\n");
 
 		dmaengine_terminate_async(drv_data->controller->dma_rx);
 		dmaengine_terminate_async(drv_data->controller->dma_tx);
@@ -145,16 +145,14 @@ int pxa2xx_spi_dma_prepare(struct driver_data *drv_data,
 
 	tx_desc = pxa2xx_spi_dma_prepare_one(drv_data, DMA_MEM_TO_DEV, xfer);
 	if (!tx_desc) {
-		dev_err(&drv_data->pdev->dev,
-			"failed to get DMA TX descriptor\n");
+		dev_err(drv_data->ssp->dev, "failed to get DMA TX descriptor\n");
 		err = -EBUSY;
 		goto err_tx;
 	}
 
 	rx_desc = pxa2xx_spi_dma_prepare_one(drv_data, DMA_DEV_TO_MEM, xfer);
 	if (!rx_desc) {
-		dev_err(&drv_data->pdev->dev,
-			"failed to get DMA RX descriptor\n");
+		dev_err(drv_data->ssp->dev, "failed to get DMA RX descriptor\n");
 		err = -EBUSY;
 		goto err_rx;
 	}
@@ -191,8 +189,8 @@ void pxa2xx_spi_dma_stop(struct driver_data *drv_data)
 int pxa2xx_spi_dma_setup(struct driver_data *drv_data)
 {
 	struct pxa2xx_spi_controller *pdata = drv_data->controller_info;
-	struct device *dev = &drv_data->pdev->dev;
 	struct spi_controller *controller = drv_data->controller;
+	struct device *dev = drv_data->ssp->dev;
 	dma_cap_mask_t mask;
 
 	dma_cap_zero(mask);

drivers/spi/spi-pxa2xx-pci.c

@@ -239,6 +239,7 @@ static int pxa2xx_spi_pci_probe(struct pci_dev *dev,
 	spi_pdata.dma_burst_size = c->dma_burst_size ? c->dma_burst_size : 1;
 
 	ssp = &spi_pdata.ssp;
+	ssp->dev = &dev->dev;
 	ssp->phys_base = pci_resource_start(dev, 0);
 	ssp->mmio_base = pcim_iomap_table(dev)[0];
 	ssp->port_id = (c->port_id >= 0) ? c->port_id : dev->devfn;

drivers/spi/spi-pxa2xx.c

@@ -628,7 +628,7 @@ static void int_error_stop(struct driver_data *drv_data, const char *msg)
 	pxa2xx_spi_flush(drv_data);
 	pxa2xx_spi_off(drv_data);
 
-	dev_err(&drv_data->pdev->dev, "%s\n", msg);
+	dev_err(drv_data->ssp->dev, "%s\n", msg);
 
 	drv_data->controller->cur_msg->status = -EIO;
 	spi_finalize_current_transfer(drv_data->controller);
@@ -731,8 +731,7 @@ static void handle_bad_msg(struct driver_data *drv_data)
 		pxa2xx_spi_write(drv_data, SSTO, 0);
 	write_SSSR_CS(drv_data, drv_data->clear_sr);
 
-	dev_err(&drv_data->pdev->dev,
-		"bad message state in interrupt handler\n");
+	dev_err(drv_data->ssp->dev, "bad message state in interrupt handler\n");
 }
 
 static irqreturn_t ssp_int(int irq, void *dev_id)
@@ -748,7 +747,7 @@ static irqreturn_t ssp_int(int irq, void *dev_id)
 	 * the IRQ was not for us (we shouldn't be RPM suspended when the
 	 * interrupt is enabled).
 	 */
-	if (pm_runtime_suspended(&drv_data->pdev->dev))
+	if (pm_runtime_suspended(drv_data->ssp->dev))
 		return IRQ_NONE;
 
 	/*
@@ -1158,7 +1157,7 @@ static int pxa2xx_spi_slave_abort(struct spi_controller *controller)
 	pxa2xx_spi_flush(drv_data);
 	pxa2xx_spi_off(drv_data);
 
-	dev_dbg(&drv_data->pdev->dev, "transfer aborted\n");
+	dev_dbg(drv_data->ssp->dev, "transfer aborted\n");
 
 	drv_data->controller->cur_msg->status = -EINTR;
 	spi_finalize_current_transfer(drv_data->controller);
@@ -1645,7 +1644,7 @@ static int pxa2xx_spi_fw_translate_cs(struct spi_controller *controller,
 {
 	struct driver_data *drv_data = spi_controller_get_devdata(controller);
 
-	if (has_acpi_companion(&drv_data->pdev->dev)) {
+	if (has_acpi_companion(drv_data->ssp->dev)) {
 		switch (drv_data->ssp_type) {
 		/*
 		 * For Atoms the ACPI DeviceSelection used by the Windows
@@ -1711,7 +1710,6 @@ static int pxa2xx_spi_probe(struct platform_device *pdev)
 	drv_data = spi_controller_get_devdata(controller);
 	drv_data->controller = controller;
 	drv_data->controller_info = platform_info;
-	drv_data->pdev = pdev;
 	drv_data->ssp = ssp;
 
 	controller->dev.of_node = pdev->dev.of_node;

drivers/spi/spi-pxa2xx.h

@@ -12,7 +12,6 @@
 #include <linux/errno.h>
 #include <linux/io.h>
 #include <linux/interrupt.h>
-#include <linux/platform_device.h>
 #include <linux/pxa2xx_ssp.h>
 #include <linux/scatterlist.h>
 #include <linux/sizes.h>
@@ -20,9 +19,6 @@
 #include <linux/spi/pxa2xx_spi.h>
 
 struct driver_data {
-	/* Driver model hookup */
-	struct platform_device *pdev;
-
 	/* SSP Info */
 	struct ssp_device *ssp;