ARM: dts: berlin: add BG2Q nodes for USB support

Adds nodes describing the Marvell Berlin BG2Q USB PHY and USB. The BG2Q
SoC has 3 USB host controller, compatible with ChipIdea.
Signed-off-by: Antoine Tenart <antoine.tenart@free-electrons.com>
Signed-off-by: Sebastian Hesselbarth <sebastian.hesselbarth@gmail.com>

arch/arm/boot/dts/berlin2q.dtsi

@@ -114,6 +114,40 @@ gic: interrupt-controller@ad1000 {
 			#interrupt-cells = <3>;
 		};
 
+		usb_phy2: phy@a2f400 {
+			compatible = "marvell,berlin2-usb-phy";
+			reg = <0xa2f400 0x128>;
+			#phy-cells = <0>;
+			resets = <&chip 0x104 14>;
+			status = "disabled";
+		};
+
+		usb2: usb@a30000 {
+			compatible = "chipidea,usb2";
+			reg = <0xa30000 0x10000>;
+			interrupts = <GIC_SPI 52 IRQ_TYPE_LEVEL_HIGH>;
+			clocks = <&chip CLKID_USB2>;
+			phys = <&usb_phy2>;
+			phy-names = "usb-phy";
+			status = "disabled";
+		};
+
+		usb_phy0: phy@b74000 {
+			compatible = "marvell,berlin2-usb-phy";
+			reg = <0xb74000 0x128>;
+			#phy-cells = <0>;
+			resets = <&chip 0x104 12>;
+			status = "disabled";
+		};
+
+		usb_phy1: phy@b78000 {
+			compatible = "marvell,berlin2-usb-phy";
+			reg = <0xb78000 0x128>;
+			#phy-cells = <0>;
+			resets = <&chip 0x104 13>;
+			status = "disabled";
+		};
+
 		eth0: ethernet@b90000 {
 			compatible = "marvell,pxa168-eth";
 			reg = <0xb90000 0x10000>;
@@ -404,6 +438,26 @@ sata-phy@1 {
 			};
 		};
 
+		usb0: usb@ed0000 {
+			compatible = "chipidea,usb2";
+			reg = <0xed0000 0x10000>;
+			interrupts = <GIC_SPI 11 IRQ_TYPE_LEVEL_HIGH>;
+			clocks = <&chip CLKID_USB0>;
+			phys = <&usb_phy0>;
+			phy-names = "usb-phy";
+			status = "disabled";
+		};
+
+		usb1: usb@ee0000 {
+			compatible = "chipidea,usb2";
+			reg = <0xee0000 0x10000>;
+			interrupts = <GIC_SPI 12 IRQ_TYPE_LEVEL_HIGH>;
+			clocks = <&chip CLKID_USB1>;
+			phys = <&usb_phy1>;
+			phy-names = "usb-phy";
+			status = "disabled";
+		};
+
 		apb@fc0000 {
 			compatible = "simple-bus";
 			#address-cells = <1>;