Merge branch 'series-to-deliver-ethernet-for-stm32mp25'

Christophe Roullier says:

====================
Series to deliver Ethernet for STM32MP25

STM32MP25 is STM32 SOC with 2 GMACs instances.
    GMAC IP version is SNPS 5.3x.
    GMAC IP configure with 2 RX and 4 TX queue.
    DMA HW capability register supported
    RX Checksum Offload Engine supported
    TX Checksum insertion supported
    Wake-Up On Lan supported
    TSO supported
====================

Link: https://lore.kernel.org/r/20240624071052.118042-1-christophe.roullier@foss.st.comSigned-off-by: Paolo Abeni <pabeni@redhat.com>

Documentation/devicetree/bindings/net/stm32-dwmac.yaml

@@ -23,12 +23,17 @@ select:
           - st,stm32-dwmac
           - st,stm32mp1-dwmac
           - st,stm32mp13-dwmac
+          - st,stm32mp25-dwmac
   required:
     - compatible
 
 properties:
   compatible:
     oneOf:
+      - items:
+          - enum:
+              - st,stm32mp25-dwmac
+          - const: snps,dwmac-5.20
       - items:
           - enum:
               - st,stm32mp1-dwmac
@@ -121,8 +126,9 @@ allOf:
         compatible:
           contains:
             enum:
-              - st,stm32mp1-dwmac
               - st,stm32-dwmac
+              - st,stm32mp1-dwmac
+              - st,stm32mp25-dwmac
     then:
       properties:
         st,syscon:

drivers/net/ethernet/stmicro/stmmac/dwmac-stm32.c

@@ -53,7 +53,18 @@
 #define SYSCFG_MCU_ETH_SEL_MII		0
 #define SYSCFG_MCU_ETH_SEL_RMII		1
 
-/* STM32MP1 register definitions
+/* STM32MP2 register definitions */
+#define SYSCFG_MP2_ETH_MASK		GENMASK(31, 0)
+
+#define SYSCFG_ETHCR_ETH_PTP_CLK_SEL	BIT(2)
+#define SYSCFG_ETHCR_ETH_CLK_SEL	BIT(1)
+#define SYSCFG_ETHCR_ETH_REF_CLK_SEL	BIT(0)
+
+#define SYSCFG_ETHCR_ETH_SEL_MII	0
+#define SYSCFG_ETHCR_ETH_SEL_RGMII	BIT(4)
+#define SYSCFG_ETHCR_ETH_SEL_RMII	BIT(6)
+
+/* STM32MPx register definitions
  *
  * Below table summarizes the clock requirement and clock sources for
  * supported phy interface modes.
@@ -104,7 +115,7 @@ struct stm32_ops {
 	int (*parse_data)(struct stm32_dwmac *dwmac,
 			  struct device *dev);
 	bool clk_rx_enable_in_suspend;
-	bool is_mp13;
+	bool is_mp13, is_mp2;
 	u32 syscfg_clr_off;
 };
 
@@ -277,8 +288,55 @@ static int stm32mp1_configure_pmcr(struct plat_stmmacenet_data *plat_dat)
 				 dwmac->mode_mask, val);
 }
 
+static int stm32mp2_configure_syscfg(struct plat_stmmacenet_data *plat_dat)
+{
+	struct stm32_dwmac *dwmac = plat_dat->bsp_priv;
+	u32 reg = dwmac->mode_reg;
+	int val = 0;
+
+	switch (plat_dat->mac_interface) {
+	case PHY_INTERFACE_MODE_MII:
+		/* ETH_REF_CLK_SEL bit in SYSCFG register is not applicable in MII mode */
+		break;
+	case PHY_INTERFACE_MODE_RMII:
+		val = SYSCFG_ETHCR_ETH_SEL_RMII;
+		if (dwmac->enable_eth_ck) {
+			/* Internal clock ETH_CLK of 50MHz from RCC is used */
+			val |= SYSCFG_ETHCR_ETH_REF_CLK_SEL;
+		}
+		break;
+	case PHY_INTERFACE_MODE_RGMII:
+	case PHY_INTERFACE_MODE_RGMII_ID:
+	case PHY_INTERFACE_MODE_RGMII_RXID:
+	case PHY_INTERFACE_MODE_RGMII_TXID:
+		val = SYSCFG_ETHCR_ETH_SEL_RGMII;
+		fallthrough;
+	case PHY_INTERFACE_MODE_GMII:
+		if (dwmac->enable_eth_ck) {
+			/* Internal clock ETH_CLK of 125MHz from RCC is used */
+			val |= SYSCFG_ETHCR_ETH_CLK_SEL;
+		}
+		break;
+	default:
+		dev_err(dwmac->dev, "Mode %s not supported",
+			phy_modes(plat_dat->mac_interface));
+		/* Do not manage others interfaces */
+		return -EINVAL;
+	}
+
+	dev_dbg(dwmac->dev, "Mode %s", phy_modes(plat_dat->mac_interface));
+
+	/* Select PTP (IEEE1588) clock selection from RCC (ck_ker_ethxptp) */
+	val |= SYSCFG_ETHCR_ETH_PTP_CLK_SEL;
+
+	/* Update ETHCR (set register) */
+	return regmap_update_bits(dwmac->regmap, reg,
+				 SYSCFG_MP2_ETH_MASK, val);
+}
+
 static int stm32mp1_set_mode(struct plat_stmmacenet_data *plat_dat)
 {
+	struct stm32_dwmac *dwmac = plat_dat->bsp_priv;
 	int ret;
 
 	ret = stm32mp1_select_ethck_external(plat_dat);
@@ -289,7 +347,10 @@ static int stm32mp1_set_mode(struct plat_stmmacenet_data *plat_dat)
 	if (ret)
 		return ret;
 
-	return stm32mp1_configure_pmcr(plat_dat);
+	if (!dwmac->ops->is_mp2)
+		return stm32mp1_configure_pmcr(plat_dat);
+	else
+		return stm32mp2_configure_syscfg(plat_dat);
 }
 
 static int stm32mcu_set_mode(struct plat_stmmacenet_data *plat_dat)
@@ -365,6 +426,9 @@ static int stm32_dwmac_parse_data(struct stm32_dwmac *dwmac,
 		return err;
 	}
 
+	if (dwmac->ops->is_mp2)
+		return 0;
+
 	dwmac->mode_mask = SYSCFG_MP1_ETH_MASK;
 	err = of_property_read_u32_index(np, "st,syscon", 2, &dwmac->mode_mask);
 	if (err) {
@@ -586,10 +650,20 @@ static struct stm32_ops stm32mp13_dwmac_data = {
 	.clk_rx_enable_in_suspend = true
 };
 
+static struct stm32_ops stm32mp25_dwmac_data = {
+	.set_mode = stm32mp1_set_mode,
+	.suspend = stm32mp1_suspend,
+	.resume = stm32mp1_resume,
+	.parse_data = stm32mp1_parse_data,
+	.is_mp2 = true,
+	.clk_rx_enable_in_suspend = true
+};
+
 static const struct of_device_id stm32_dwmac_match[] = {
 	{ .compatible = "st,stm32-dwmac", .data = &stm32mcu_dwmac_data},
 	{ .compatible = "st,stm32mp1-dwmac", .data = &stm32mp1_dwmac_data},
 	{ .compatible = "st,stm32mp13-dwmac", .data = &stm32mp13_dwmac_data},
+	{ .compatible = "st,stm32mp25-dwmac", .data = &stm32mp25_dwmac_data},
 	{ }
 };
 MODULE_DEVICE_TABLE(of, stm32_dwmac_match);