Commit cf065a7d authored by Randy Dunlap's avatar Randy Dunlap Committed by Martin K. Petersen

scsi: Documentation: Correct spelling

Correct spelling problems for Documentation/scsi/ as reported by codespell.

Link: https://lore.kernel.org/r/20230129231053.20863-8-rdunlap@infradead.orgSigned-off-by: default avatarRandy Dunlap <rdunlap@infradead.org>
Cc: Jonathan Corbet <corbet@lwn.net>
Cc: linux-doc@vger.kernel.org
Cc: "James E.J. Bottomley" <jejb@linux.ibm.com>
Cc: "Martin K. Petersen" <martin.petersen@oracle.com>
Cc: linux-scsi@vger.kernel.org
Signed-off-by: default avatarMartin K. Petersen <martin.petersen@oracle.com>
parent 685d5ef4
......@@ -906,7 +906,7 @@ burst:#x burst enabled (1<<#x burst transfers max)
led:0 disable LED support
===== ===================
Donnot enable LED support if your scsi board does not use SDMS BIOS.
Do not enable LED support if your scsi board does not use SDMS BIOS.
(See 'Configuration parameters')
10.2.13 Max wide
......@@ -1222,7 +1222,7 @@ Unfortunately, the following common SCSI BUS problems are not detected:
- Bad quality terminators.
On the other hand, either bad cabling, broken devices, not conformant
devices, ... may cause a SCSI signal to be wrong when te driver reads it.
devices, ... may cause a SCSI signal to be wrong when the driver reads it.
10.7 IMMEDIATE ARBITRATION boot option
^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^
......
......@@ -703,7 +703,7 @@ Unfortunately, the following common SCSI BUS problems are not detected:
- Bad quality terminators.
On the other hand, either bad cabling, broken devices, not conformant
devices, ... may cause a SCSI signal to be wrong when te driver reads it.
devices, ... may cause a SCSI signal to be wrong when the driver reads it.
15. SCSI problem troubleshooting
================================
......
......@@ -6,7 +6,7 @@ tcm_qla2xxx Driver Notes
tcm_qla2xxx jam_host attribute
------------------------------
There is now a new module endpoint atribute called jam_host
There is now a new module endpoint attribute called jam_host
attribute::
jam_host: boolean=0/1
......
......@@ -206,5 +206,5 @@ Device-Specific Data property named "ref-clk-freq". In both ways the value
is interpreted as frequency in Hz and must match one of the values given in
the UFS specification. UFS subsystem will attempt to read the value when
executing common controller initialization. If the value is available, UFS
subsytem will ensure the bRefClkFreq attribute of the UFS storage device is
subsystem will ensure the bRefClkFreq attribute of the UFS storage device is
set accordingly and will modify it if there is a mismatch.
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment