arm64: dts: qcom: msm8916-samsung-j5: Add sound and modem

Enable sound and modem for the Samsung J5 smartphones. The setup is
similar to most MSM8916 devices, i.e.:

 - QDSP6 audio
 - Speaker/earpiece/headphones/microphones via digital/analog codec
   in MSM8916/PM8916
 - WWAN Internet via BAM-DMUX

except:

 - There is no secondary microphone, so a different "model" is used to
   differentiate that in the UCM configuration.
 - Samsung-specific audio jack detection (not supported yet)
Co-developed-by: Markuss Broks <markuss.broks@gmail.com>
Signed-off-by: Markuss Broks <markuss.broks@gmail.com>
Signed-off-by: "Lin, Meng-Bo" <linmengbo0689@protonmail.com>
[Stephan: Add consistent commit message]
Signed-off-by: Stephan Gerhold <stephan@gerhold.net>
Link: https://lore.kernel.org/r/20231003-msm8916-modem-v2-13-61b684be55c0@gerhold.netSigned-off-by: Bjorn Andersson <andersson@kernel.org>

arch/arm64/boot/dts/qcom/msm8916-samsung-j5-common.dtsi

 // SPDX-License-Identifier: GPL-2.0-only
 
 #include "msm8916-pm8916.dtsi"
+#include "msm8916-modem-qdsp6.dtsi"
+
 #include <dt-bindings/gpio/gpio.h>
 #include <dt-bindings/input/input.h>
 #include <dt-bindings/interrupt-controller/irq.h>
@@ -135,6 +137,10 @@ &blsp_uart2 {
 	status = "okay";
 };
 
+&mpss_mem {
+	reg = <0x0 0x86800000 0x0 0x5800000>;
+};
+
 &pm8916_resin {
 	status = "okay";
 	linux,code = <KEY_VOLUMEDOWN>;
@@ -154,6 +160,14 @@ &sdhc_2 {
 	cd-gpios = <&tlmm 38 GPIO_ACTIVE_LOW>;
 };
 
+&sound {
+	model = "msm8916-1mic";
+	audio-routing =
+		"AMIC1", "MIC BIAS External1",
+		"AMIC2", "MIC BIAS Internal2",
+		"AMIC3", "MIC BIAS External1";
+};
+
 &usb {
 	extcon = <&muic>, <&muic>;
 	status = "okay";

arch/arm64/boot/dts/qcom/msm8916-samsung-j5.dts

@@ -19,6 +19,10 @@ &blsp_i2c5 {
 	status = "disabled";
 };
 
+&pm8916_codec {
+	qcom,micbias1-ext-cap;
+};
+
 &touchscreen {
 	/* FIXME: Missing sm5703-mfd driver to power up vdd-supply */
 };