net: xen-netback: correctly restart Tx after a VM restore/migrate

If a VM is saved and restored (or migrated) the netback driver will no
longer process any Tx packets from the frontend.  xenvif_up() does not
schedule the processing of any pending Tx requests from the front end
because the carrier is off.  Without this initial kick the frontend
just adds Tx requests to the ring without raising an event (until the
ring is full).

This was caused by 47103041 (net:
xen-netback: convert to hw_features) which reordered the calls to
xenvif_up() and netif_carrier_on() in xenvif_connect().
Signed-off-by: David Vrabel <david.vrabel@citrix.com>
Cc: Ian Campbell <ian.campbell@citrix.com>
Acked-by: Ian Campbell <ian.campbell@citrix.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

drivers/net/xen-netback/interface.c

@@ -327,12 +327,12 @@ int xenvif_connect(struct xenvif *vif, unsigned long tx_ring_ref,
 	xenvif_get(vif);
 
 	rtnl_lock();
-	if (netif_running(vif->dev))
-		xenvif_up(vif);
 	if (!vif->can_sg && vif->dev->mtu > ETH_DATA_LEN)
 		dev_set_mtu(vif->dev, ETH_DATA_LEN);
 	netdev_update_features(vif->dev);
 	netif_carrier_on(vif->dev);
+	if (netif_running(vif->dev))
+		xenvif_up(vif);
 	rtnl_unlock();
 
 	return 0;