drm/bridge: synopsys: dw-mipi-dsi: Set minimum lane byte clock cycles for HSA and HBP
According to Synopsys support channel, each region of HSA, HBP and HFP must have minimum number of 10 bytes where constant 4 bytes are for HSS or HSE and 6 bytes are for blanking packet(header + CRC). Hence, the below table comes in. +------------+----------+-------+ | data lanes | min lbcc | bytes | +------------+----------+-------+ | 1 | 10 | 1*10 | +------------+----------+-------+ | 2 | 5 | 2*5 | +------------+----------+-------+ | 3 | 4 | 3*4 | +------------+----------+-------+ | 4 | 3 | 4*3 | +------------+----------+-------+ Implement the minimum lbcc numbers to make sure that the values programmed into DSI_VID_HSA_TIME and DSI_VID_HBP_TIME registers meet the minimum number requirement. For DSI_VID_HLINE_TIME register, it seems that the value programmed should be based on mode->htotal as-is, instead of sum up HSA, HBP, HFP and HDISPLAY. This helps the case where Raydium RM67191 DSI panel is connected, since it's video timing for hsync length is only 2 pixels and without this patch the programmed value for DSI_VID_HSA_TIME is only 2 with 4 data lanes. Signed-off-by: Liu Ying <victor.liu@nxp.com> Reviewed-by: Neil Armstrong <neil.armstrong@linaro.org> Signed-off-by: Robert Foss <rfoss@kernel.org> Link: https://patchwork.freedesktop.org/patch/msgid/20230821034008.3876938-7-victor.liu@nxp.com
Showing
Please register or sign in to comment