Commit d84ca5b3 authored by Wolfram Sang's avatar Wolfram Sang Committed by Jean Delvare

hwmon: Add driver for ADT7411 voltage and temperature sensor

Add basic support for the ADT7411. Reads out all conversion results (via I2C,
SPI yet missing) and allows some on-the-fly configuration. Tested with a
custom board.
Signed-off-by: default avatarSascha Hauer <s.hauer@pengutronix.de>
Signed-off-by: default avatarWolfram Sang <w.sang@pengutronix.de>
Signed-off-by: default avatarJean Delvare <khali@linux-fr.org>
parent 5852f960
Kernel driver adt7411
=====================
Supported chips:
* Analog Devices ADT7411
Prefix: 'adt7411'
Addresses scanned: 0x48, 0x4a, 0x4b
Datasheet: Publicly available at the Analog Devices website
Author: Wolfram Sang (based on adt7470 by Darrick J. Wong)
Description
-----------
This driver implements support for the Analog Devices ADT7411 chip. There may
be other chips that implement this interface.
The ADT7411 can use an I2C/SMBus compatible 2-wire interface or an
SPI-compatible 4-wire interface. It provides a 10-bit analog to digital
converter which measures 1 temperature, vdd and 8 input voltages. It has an
internal temperature sensor, but an external one can also be connected (one
loses 2 inputs then). There are high- and low-limit registers for all inputs.
Check the datasheet for details.
sysfs-Interface
---------------
in0_input - vdd voltage input
in[1-8]_input - analog 1-8 input
temp1_input - temperature input
Besides standard interfaces, this driver adds (0 = off, 1 = on):
adc_ref_vdd - Use vdd as reference instead of 2.25 V
fast_sampling - Sample at 22.5 kHz instead of 1.4 kHz, but drop filters
no_average - Turn off averaging over 16 samples
Notes
-----
SPI, external temperature sensor and limit registers are not supported yet.
......@@ -170,6 +170,16 @@ config SENSORS_ADM9240
This driver can also be built as a module. If so, the module
will be called adm9240.
config SENSORS_ADT7411
tristate "Analog Devices ADT7411"
depends on I2C && EXPERIMENTAL
help
If you say yes here you get support for the Analog Devices
ADT7411 voltage and temperature monitoring chip.
This driver can also be built as a module. If so, the module
will be called adt7411.
config SENSORS_ADT7462
tristate "Analog Devices ADT7462"
depends on I2C && EXPERIMENTAL
......
......@@ -29,6 +29,7 @@ obj-$(CONFIG_SENSORS_ADM1029) += adm1029.o
obj-$(CONFIG_SENSORS_ADM1031) += adm1031.o
obj-$(CONFIG_SENSORS_ADM9240) += adm9240.o
obj-$(CONFIG_SENSORS_ADS7828) += ads7828.o
obj-$(CONFIG_SENSORS_ADT7411) += adt7411.o
obj-$(CONFIG_SENSORS_ADT7462) += adt7462.o
obj-$(CONFIG_SENSORS_ADT7470) += adt7470.o
obj-$(CONFIG_SENSORS_ADT7473) += adt7473.o
......
This diff is collapsed.
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment