cxl: Fix cleanup of port devices on failure to probe driver.

The device is created, and then there is a check if a driver succesfully
bound to it. In event of failing the bind (e.g. failure in cxl_port_probe())
the device is left registered. When a bus rescan later occurs, fresh
devices are created leading to a multiple device representing the same
underlying hardware. Bad things may follow and at very least we have far too many
devices.

Fix by ensuring autoremove is registered if the device create succeeds,
but doesn't depend on sucessful binding to a driver.

Bug was observed as side effect of incorrect ownership in
[PATCH v9 6/9] cxl/port: Read CDAT table
but will result from any failure to in cxl_port_probe().

Fixes: 8dd2bc0f ("cxl/mem: Add the cxl_mem driver")
Signed-off-by: Jonathan Cameron <Jonathan.Cameron@huawei.com>
Reviewed-by: Ira Weiny <ira.weiny@intel.com>
Link: https://lore.kernel.org/r/20220609134519.11668-1-Jonathan.Cameron@huawei.comSigned-off-by: Dan Williams <dan.j.williams@intel.com>

drivers/cxl/mem.c

@@ -29,6 +29,7 @@ static int create_endpoint(struct cxl_memdev *cxlmd,
 {
 	struct cxl_dev_state *cxlds = cxlmd->cxlds;
 	struct cxl_port *endpoint;
+	int rc;
 
 	endpoint = devm_cxl_add_port(&parent_port->dev, &cxlmd->dev,
 				     cxlds->component_reg_phys, parent_port);
@@ -37,13 +38,17 @@ static int create_endpoint(struct cxl_memdev *cxlmd,
 
 	dev_dbg(&cxlmd->dev, "add: %s\n", dev_name(&endpoint->dev));
 
+	rc = cxl_endpoint_autoremove(cxlmd, endpoint);
+	if (rc)
+		return rc;
+
 	if (!endpoint->dev.driver) {
 		dev_err(&cxlmd->dev, "%s failed probe\n",
 			dev_name(&endpoint->dev));
 		return -ENXIO;
 	}
 
-	return cxl_endpoint_autoremove(cxlmd, endpoint);
+	return 0;
 }
 
 static void enable_suspend(void *data)