net: qualcomm: add QCA7000 UART driver

This patch adds the Ethernet over UART driver for the
Qualcomm QCA7000 HomePlug GreenPHY.
Signed-off-by: Stefan Wahren <stefan.wahren@i2se.com>
Reviewed-by: Lino Sanfilippo <LinoSanfilippo@gmx.de>
Signed-off-by: David S. Miller <davem@davemloft.net>

drivers/net/ethernet/qualcomm/Kconfig

@@ -30,6 +30,22 @@ config QCA7000_SPI
 	  To compile this driver as a module, choose M here. The module
 	  will be called qcaspi.
 
+config QCA7000_UART
+	tristate "Qualcomm Atheros QCA7000 UART support"
+	select QCA7000
+	depends on SERIAL_DEV_BUS && OF
+	---help---
+	  This UART protocol driver supports the Qualcomm Atheros QCA7000.
+
+	  Currently the driver assumes these device UART settings:
+	    Data bits: 8
+	    Parity: None
+	    Stop bits: 1
+	    Flow control: None
+
+	  To compile this driver as a module, choose M here. The module
+	  will be called qcauart.
+
 config QCOM_EMAC
 	tristate "Qualcomm Technologies, Inc. EMAC Gigabit Ethernet support"
 	depends on HAS_DMA && HAS_IOMEM

drivers/net/ethernet/qualcomm/Makefile

@@ -5,5 +5,7 @@
 obj-$(CONFIG_QCA7000) += qca_7k_common.o
 obj-$(CONFIG_QCA7000_SPI) += qcaspi.o
 qcaspi-objs := qca_7k.o qca_debug.o qca_spi.o
+obj-$(CONFIG_QCA7000_UART) += qcauart.o
+qcauart-objs := qca_uart.o
 
 obj-y += emac/

drivers/net/ethernet/qualcomm/qca_7k_common.h

@@ -122,6 +122,12 @@ static inline void qcafrm_fsm_init_spi(struct qcafrm_handle *handle)
 	handle->state = handle->init;
 }
 
+static inline void qcafrm_fsm_init_uart(struct qcafrm_handle *handle)
+{
+	handle->init = QCAFRM_WAIT_AA1;
+	handle->state = handle->init;
+}
+
 /*   Gather received bytes and try to extract a full Ethernet frame
  *   by following a simple state machine.
  *