wcn36xx: Set PHY into correct mode for 80MHz channel width

For the 80MHz channel we need to set the PHY mode to one of four PHY modes
that span the 80MHz range.

This patch latches the hw_value PHY field previously defined for 5GHz
channels directly to the parameter passed to the firmware.
Signed-off-by: Bryan O'Donoghue <bryan.odonoghue@linaro.org>
Signed-off-by: Kalle Valo <kvalo@codeaurora.org>
Link: https://lore.kernel.org/r/20200910150708.2179043-6-bryan.odonoghue@linaro.org

drivers/net/wireless/ath/wcn36xx/smd.c

@@ -1508,6 +1508,7 @@ static int wcn36xx_smd_config_bss_v1(struct wcn36xx *wcn,
 	struct wcn36xx_hal_config_bss_params_v1 *bss;
 	struct wcn36xx_hal_config_bss_params bss_v0;
 	struct wcn36xx_hal_config_sta_params_v1 *sta;
+	struct cfg80211_chan_def *chandef;
 	int ret;
 
 	msg_body = kzalloc(sizeof(*msg_body), GFP_KERNEL);
@@ -1547,7 +1548,13 @@ static int wcn36xx_smd_config_bss_v1(struct wcn36xx *wcn,
 	bss->dtim_period = bss_v0.dtim_period;
 	bss->tx_channel_width_set = bss_v0.tx_channel_width_set;
 	bss->oper_channel = bss_v0.oper_channel;
-	bss->ext_channel = bss_v0.ext_channel;
+
+	if (wcn->hw->conf.chandef.width == NL80211_CHAN_WIDTH_80) {
+		chandef = &wcn->hw->conf.chandef;
+		bss->ext_channel = HW_VALUE_PHY(chandef->chan->hw_value);
+	} else {
+		bss->ext_channel = bss_v0.ext_channel;
+	}
 
 	bss->reserved = bss_v0.reserved;