omap_hsmmc: set a large data timeout for commands with busy signal

Commands like SWITCH (CMD6) send a response and then signal busy while the
operation is completed.  These commands are expected to always succeed
(otherwise the response would have indicated an error).

Set an arbitrarily large data timeout value (100ms) for these commands to
ensure that premature timeouts do not occur.
Signed-off-by: Adrian Hunter <adrian.hunter@nokia.com>
Acked-by: Matt Fleming <matt@console-pimps.org>
Cc: Ian Molton <ian@mnementh.co.uk>
Cc: "Roberto A. Foglietta" <roberto.foglietta@gmail.com>
Cc: Jarkko Lavinen <jarkko.lavinen@nokia.com>
Cc: Denis Karpov <ext-denis.2.karpov@nokia.com>
Cc: Pierre Ossman <pierre@ossman.eu>
Cc: Philip Langdale <philipl@overt.org>
Cc: "Madhusudhan" <madhu.cr@ti.com>
Cc: <linux-mmc@vger.kernel.org>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>

drivers/mmc/host/omap_hsmmc.c

@@ -997,7 +997,8 @@ static int omap_hsmmc_start_dma_transfer(struct omap_hsmmc_host *host,
 }
 
 static void set_data_timeout(struct omap_hsmmc_host *host,
-			     struct mmc_request *req)
+			     unsigned int timeout_ns,
+			     unsigned int timeout_clks)
 {
 	unsigned int timeout, cycle_ns;
 	uint32_t reg, clkd, dto = 0;
@@ -1008,8 +1009,8 @@ static void set_data_timeout(struct omap_hsmmc_host *host,
 		clkd = 1;
 
 	cycle_ns = 1000000000 / (clk_get_rate(host->fclk) / clkd);
-	timeout = req->data->timeout_ns / cycle_ns;
-	timeout += req->data->timeout_clks;
+	timeout = timeout_ns / cycle_ns;
+	timeout += timeout_clks;
 	if (timeout) {
 		while ((timeout & 0x80000000) == 0) {
 			dto += 1;
@@ -1043,12 +1044,18 @@ omap_hsmmc_prepare_data(struct omap_hsmmc_host *host, struct mmc_request *req)
 
 	if (req->data == NULL) {
 		OMAP_HSMMC_WRITE(host->base, BLK, 0);
+		/*
+		 * Set an arbitrary 100ms data timeout for commands with
+		 * busy signal.
+		 */
+		if (req->cmd->flags & MMC_RSP_BUSY)
+			set_data_timeout(host, 100000000U, 0);
 		return 0;
 	}
 
 	OMAP_HSMMC_WRITE(host->base, BLK, (req->data->blksz)
 					| (req->data->blocks << 16));
-	set_data_timeout(host, req);
+	set_data_timeout(host, req->data->timeout_ns, req->data->timeout_clks);
 
 	if (host->use_dma) {
 		ret = omap_hsmmc_start_dma_transfer(host, req);