net: dsa: ocelot: remove interface checks

When the supported interfaces bitmap is populated, phylink will itself
check that the interface mode is present in this bitmap. Drivers no
longer need to perform this check themselves. Remove these checks.
Reviewed-by: Vladimir Oltean <vladimir.oltean@nxp.com>
Tested-by: Vladimir Oltean <vladimir.oltean@nxp.com>
Signed-off-by: Russell King (Oracle) <rmk+kernel@armlinux.org.uk>
Signed-off-by: David S. Miller <davem@davemloft.net>

drivers/net/dsa/ocelot/felix_vsc9959.c

@@ -944,15 +944,8 @@ static void vsc9959_phylink_validate(struct ocelot *ocelot, int port,
 				     unsigned long *supported,
 				     struct phylink_link_state *state)
 {
-	struct ocelot_port *ocelot_port = ocelot->ports[port];
 	__ETHTOOL_DECLARE_LINK_MODE_MASK(mask) = { 0, };
 
-	if (state->interface != PHY_INTERFACE_MODE_NA &&
-	    state->interface != ocelot_port->phy_mode) {
-		linkmode_zero(supported);
-		return;
-	}
-
 	phylink_set_port_modes(mask);
 	phylink_set(mask, Autoneg);
 	phylink_set(mask, Pause);

drivers/net/dsa/ocelot/seville_vsc9953.c

@@ -917,15 +917,8 @@ static void vsc9953_phylink_validate(struct ocelot *ocelot, int port,
 				     unsigned long *supported,
 				     struct phylink_link_state *state)
 {
-	struct ocelot_port *ocelot_port = ocelot->ports[port];
 	__ETHTOOL_DECLARE_LINK_MODE_MASK(mask) = { 0, };
 
-	if (state->interface != PHY_INTERFACE_MODE_NA &&
-	    state->interface != ocelot_port->phy_mode) {
-		linkmode_zero(supported);
-		return;
-	}
-
 	phylink_set_port_modes(mask);
 	phylink_set(mask, Autoneg);
 	phylink_set(mask, Pause);