PCI: aardvark: Set PIO_ADDR_LS correctly in advk_pcie_rd_conf()

commit 4fa3999e upstream.

When setting the PIO_ADDR_LS register during a configuration read, we
were properly passing the device number, function number and register
number, but not the bus number, causing issues when reading the
configuration of PCIe devices.

Fixes: 8c39d710 ("PCI: aardvark: Add Aardvark PCI host controller driver")
Cc: <stable@vger.kernel.org>
Signed-off-by: Victor Gu <xigu@marvell.com>
Reviewed-by: Wilson Ding <dingwei@marvell.com>
Reviewed-by: Nadav Haklai <nadavh@marvell.com>
[Thomas: tweak commit log.]
Signed-off-by: Thomas Petazzoni <thomas.petazzoni@bootlin.com>
Signed-off-by: Lorenzo Pieralisi <lorenzo.pieralisi@arm.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

drivers/pci/host/pci-aardvark.c

@@ -175,8 +175,6 @@
 #define PCIE_CONFIG_WR_TYPE0			0xa
 #define PCIE_CONFIG_WR_TYPE1			0xb
 
-/* PCI_BDF shifts 8bit, so we need extra 4bit shift */
-#define PCIE_BDF(dev)				(dev << 4)
 #define PCIE_CONF_BUS(bus)			(((bus) & 0xff) << 20)
 #define PCIE_CONF_DEV(dev)			(((dev) & 0x1f) << 15)
 #define PCIE_CONF_FUNC(fun)			(((fun) & 0x7)	<< 12)
@@ -458,7 +456,7 @@ static int advk_pcie_rd_conf(struct pci_bus *bus, u32 devfn,
 	advk_writel(pcie, reg, PIO_CTRL);
 
 	/* Program the address registers */
-	reg = PCIE_BDF(devfn) | PCIE_CONF_REG(where);
+	reg = PCIE_CONF_ADDR(bus->number, devfn, where);
 	advk_writel(pcie, reg, PIO_ADDR_LS);
 	advk_writel(pcie, 0, PIO_ADDR_MS);