[SCSI] qla4xxx: do not process interrupt unconditionally

in mailbox command do not process interrupt unconditionally,
process interrupt only in polling mode
Signed-off-by: Vikas Chaudhary <vikas.chaudhary@qlogic.com>
Signed-off-by: Lalit Chandivade <lalit.chandivade@qlogic.com>
Signed-off-by: Ravi Anand <ravi.anand@qlogic.com>
Signed-off-by: James Bottomley <James.Bottomley@suse.de>

drivers/scsi/qla4xxx/ql4_mbx.c

@@ -81,23 +81,7 @@ int qla4xxx_mailbox_command(struct scsi_qla_host *ha, uint8_t inCount,
 	 */
 	spin_lock_irqsave(&ha->hardware_lock, flags);
 
-	if (is_qla8022(ha)) {
-		intr_status = readl(&ha->qla4_8xxx_reg->host_int);
-		if (intr_status & ISRX_82XX_RISC_INT) {
-			/* Service existing interrupt */
-			DEBUG2(printk("scsi%ld: %s: "
-			    "servicing existing interrupt\n",
-			    ha->host_no, __func__));
-			intr_status = readl(&ha->qla4_8xxx_reg->host_status);
-			ha->isp_ops->interrupt_service_routine(ha, intr_status);
-			clear_bit(AF_MBOX_COMMAND_DONE, &ha->flags);
-			if (test_bit(AF_INTERRUPTS_ON, &ha->flags) &&
-			    test_bit(AF_INTx_ENABLED, &ha->flags))
-				qla4_8xxx_wr_32(ha,
-				    ha->nx_legacy_intr.tgt_mask_reg,
-				    0xfbff);
-		}
-	} else {
+	if (!is_qla8022(ha)) {
 		intr_status = readl(&ha->reg->ctrl_status);
 		if (intr_status & CSR_SCSI_PROCESSOR_INTR) {
 			/* Service existing interrupt */