i40e: use declared variables for pf and hw

In order to slightly simplify the code use the variables for pf and hw
that are declared in i40e_set_mac function.
Signed-off-by: Patryk Małek <patryk.malek@intel.com>
Tested-by: Andrew Bowers <andrewx.bowers@intel.com>
Signed-off-by: Jeff Kirsher <jeffrey.t.kirsher@intel.com>

drivers/net/ethernet/intel/i40e/i40e_main.c

@@ -1532,8 +1532,8 @@ static int i40e_set_mac(struct net_device *netdev, void *p)
 		return 0;
 	}
 
-	if (test_bit(__I40E_VSI_DOWN, vsi->back->state) ||
-	    test_bit(__I40E_RESET_RECOVERY_PENDING, vsi->back->state))
+	if (test_bit(__I40E_DOWN, pf->state) ||
+	    test_bit(__I40E_RESET_RECOVERY_PENDING, pf->state))
 		return -EADDRNOTAVAIL;
 
 	if (ether_addr_equal(hw->mac.addr, addr->sa_data))
@@ -1557,8 +1557,7 @@ static int i40e_set_mac(struct net_device *netdev, void *p)
 	if (vsi->type == I40E_VSI_MAIN) {
 		i40e_status ret;
 
-		ret = i40e_aq_mac_address_write(&vsi->back->hw,
-						I40E_AQC_WRITE_TYPE_LAA_WOL,
+		ret = i40e_aq_mac_address_write(hw, I40E_AQC_WRITE_TYPE_LAA_WOL,
 						addr->sa_data, NULL);
 		if (ret)
 			netdev_info(netdev, "Ignoring error from firmware on LAA update, status %s, AQ ret %s\n",
@@ -1569,7 +1568,7 @@ static int i40e_set_mac(struct net_device *netdev, void *p)
 	/* schedule our worker thread which will take care of
 	 * applying the new filter changes
 	 */
-	i40e_service_event_schedule(vsi->back);
+	i40e_service_event_schedule(pf);
 	return 0;
 }