platform/x86: thinkpad_acpi: Disable DYTC CQL mode around switching to balanced mode

Testing has shown that setting /sys/firmware/acpi/platform_profile to
"balanced" when /sys/bus/platform/devices/thinkpad_acpi/dytc_lapmode
reports 1, causes dytc_lapmode to get reset to 0 and then it becomes
stuck at 0 for aprox. 30 minutes even if the laptop is used on a lap.

Disabling CQL (when enabled) before issuing the DYTC_CMD_RESET to get
back to balanced mode and re-enabling it afterwards again, like the
code already does when switching to low-power / performance mode fixes
this.

Fixes: c3bfcd4c ("platform/x86: thinkpad_acpi: Add platform profile support")
Tested-by: Mark Pearson <markpearson@lenovo.com>
Signed-off-by: Hans de Goede <hdegoede@redhat.com>
Link: https://lore.kernel.org/r/20210321113108.7069-1-hdegoede@redhat.com

drivers/platform/x86/thinkpad_acpi.c

@@ -10187,8 +10187,13 @@ static int dytc_profile_set(struct platform_profile_handler *pprof,
 		return err;
 
 	if (profile == PLATFORM_PROFILE_BALANCED) {
-		/* To get back to balanced mode we just issue a reset command */
-		err = dytc_command(DYTC_CMD_RESET, &output);
+		/*
+		 * To get back to balanced mode we need to issue a reset command.
+		 * Note we still need to disable CQL mode before hand and re-enable
+		 * it afterwards, otherwise dytc_lapmode gets reset to 0 and stays
+		 * stuck at 0 for aprox. 30 minutes.
+		 */
+		err = dytc_cql_command(DYTC_CMD_RESET, &output);
 		if (err)
 			goto unlock;
 	} else {