Commit ecb010d4 authored by Nuno Sá's avatar Nuno Sá Committed by Jonathan Cameron

iio: imu: adis: Refactor adis_initial_startup

All the ADIS devices perform, at the beginning, a self test to make sure
the device is in a sane state. Previously, the logic was that the self-test
was performed in adis_initial_startup() and if that failed a reset was done
and then a self-test was attempted again.

This change unifies the reset mechanism under the adis_initial_startup()
call. A HW reset will be done if  GPIO is configured, or a SW reset
otherwise. This should make sure that the chip is in a sane state for
self-test. Once the reset is done, the self-test operation will be
performed. If anything goes wrong with self-test, the driver should just
bail/error-out (i.e. no second attempt). The chip would likely not be a in
a sane state state if the self-test fails after a reset.
Signed-off-by: default avatarNuno Sá <nuno.sa@analog.com>
Signed-off-by: default avatarAlexandru Ardelean <alexandru.ardelean@analog.com>
Signed-off-by: default avatarJonathan Cameron <Jonathan.Cameron@huawei.com>
parent fdcf6bbb
......@@ -7,6 +7,7 @@
*/
#include <linux/delay.h>
#include <linux/gpio/consumer.h>
#include <linux/mutex.h>
#include <linux/device.h>
#include <linux/kernel.h>
......@@ -368,6 +369,10 @@ static int adis_self_test(struct adis *adis)
* __adis_initial_startup() - Device initial setup
* @adis: The adis device
*
* The function performs a HW reset via a reset pin that should be specified
* via GPIOLIB. If no pin is configured a SW reset will be performed.
* The RST pin for the ADIS devices should be configured as ACTIVE_LOW.
*
* Returns 0 if the device is operational, a negative error code otherwise.
*
* This function should be called early on in the device initialization sequence
......@@ -375,18 +380,28 @@ static int adis_self_test(struct adis *adis)
*/
int __adis_initial_startup(struct adis *adis)
{
const struct adis_timeout *timeouts = adis->data->timeouts;
struct gpio_desc *gpio;
int ret;
ret = adis_self_test(adis);
if (ret) {
dev_err(&adis->spi->dev, "Self-test failed, trying reset.\n");
__adis_reset(adis);
ret = adis_self_test(adis);
/* check if the device has rst pin low */
gpio = devm_gpiod_get_optional(&adis->spi->dev, "reset", GPIOD_ASIS);
if (IS_ERR(gpio))
return PTR_ERR(gpio);
if (gpio) {
gpiod_set_value_cansleep(gpio, 1);
msleep(10);
/* bring device out of reset */
gpiod_set_value_cansleep(gpio, 0);
msleep(timeouts->reset_ms);
} else {
ret = __adis_reset(adis);
if (ret)
dev_err(&adis->spi->dev, "Second self-test failed, giving up.\n");
return ret;
}
return ret;
return adis_self_test(adis);
}
EXPORT_SYMBOL_GPL(__adis_initial_startup);
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment