Commit ed2fbf57 authored by Bryan Wu's avatar Bryan Wu Committed by Linus Torvalds

Blackfin arch: add SPI MMC driver support on bf533-stamp, tested on STAMP-BF533

Signed-off-by: default avatarBryan Wu <bryan.wu@analog.com>
Signed-off-by: default avatarLinus Torvalds <torvalds@linux-foundation.org>
parent 8af10b79
......@@ -164,6 +164,13 @@ static struct bfin5xx_spi_chip ad5304_chip_info = {
};
#endif
#if defined(CONFIG_SPI_MMC) || defined(CONFIG_SPI_MMC_MODULE)
static struct bfin5xx_spi_chip spi_mmc_chip_info = {
.enable_dma = 1,
.bits_per_word = 8,
};
#endif
static struct spi_board_info bfin_spi_board_info[] __initdata = {
#if defined(CONFIG_MTD_M25P80) || defined(CONFIG_MTD_M25P80_MODULE)
{
......@@ -199,6 +206,27 @@ static struct spi_board_info bfin_spi_board_info[] __initdata = {
},
#endif
#if defined(CONFIG_SPI_MMC) || defined(CONFIG_SPI_MMC_MODULE)
{
.modalias = "spi_mmc_dummy",
.max_speed_hz = 25000000, /* max spi clock (SCK) speed in HZ */
.bus_num = 1,
.chip_select = 0,
.platform_data = NULL,
.controller_data = &spi_mmc_chip_info,
.mode = SPI_MODE_3,
},
{
.modalias = "spi_mmc",
.max_speed_hz = 25000000, /* max spi clock (SCK) speed in HZ */
.bus_num = 1,
.chip_select = CONFIG_SPI_MMC_CS_CHAN,
.platform_data = NULL,
.controller_data = &spi_mmc_chip_info,
.mode = SPI_MODE_3,
},
#endif
#if defined(CONFIG_PBX)
{
.modalias = "fxs-spi",
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment