[TG3]: ethtool always report port is TP.

Even with fiber cards ethtool reports that the connected port is TP,
the patch fix this.
Signed-off-by: Karsten Keil <kkeil@suse.de>
Acked-by: Michael Chan <mchan@broadcom.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

drivers/net/tg3.c

@@ -7653,21 +7653,23 @@ static int tg3_get_settings(struct net_device *dev, struct ethtool_cmd *cmd)
 		cmd->supported |= (SUPPORTED_1000baseT_Half |
 				   SUPPORTED_1000baseT_Full);
 
-	if (!(tp->tg3_flags2 & TG3_FLG2_ANY_SERDES))
+	if (!(tp->tg3_flags2 & TG3_FLG2_ANY_SERDES)) {
 		cmd->supported |= (SUPPORTED_100baseT_Half |
 				  SUPPORTED_100baseT_Full |
 				  SUPPORTED_10baseT_Half |
 				  SUPPORTED_10baseT_Full |
 				  SUPPORTED_MII);
-	else
+		cmd->port = PORT_TP;
+	} else {
 		cmd->supported |= SUPPORTED_FIBRE;
+		cmd->port = PORT_FIBRE;
+	}
   
 	cmd->advertising = tp->link_config.advertising;
 	if (netif_running(dev)) {
 		cmd->speed = tp->link_config.active_speed;
 		cmd->duplex = tp->link_config.active_duplex;
 	}
-	cmd->port = 0;
 	cmd->phy_address = PHY_ADDR;
 	cmd->transceiver = 0;
 	cmd->autoneg = tp->link_config.autoneg;