regulator: bd718x7: remove voltage change restriction from BD71847

The BD71837 had a HW "feature" where changing the regulator output
voltages of other regulators but bucks 1-4 might cause spikes if
regulators were enabled. Thus SW prohibit voltage changes for other
regulators except for bucks 1-4 when regulator is enabled.

The HW colleagues did inadvertly fix this issue for BD71847 and
BD71850. Remove voltage change restrictions from other PMICs but
BD71837.

The LDO voltage changing is still restricted. I did not yet receive
answer whether there is voltage spikes to be expected for LDOs. I
only know that the power-good detection for LDOs can cause false
alarms if LDO voltage is changed when LDO is enabled. We might be
able to work-around this by disabling the power-good monioring for
the duration of the LDO voltage change - but as I said, I don't
know yet. Let's fix it later if we can confirm that also LDO voltage
changes are safe.
Signed-off-by: Matti Vaittinen <matti.vaittinen@fi.rohmeurope.com>
Link: https://lore.kernel.org/r/20200428092930.GA9721@localhost.localdomainSigned-off-by: Mark Brown <broonie@kernel.org>

drivers/regulator/bd718x7-regulator.c

@@ -55,10 +55,15 @@ static int bd718xx_buck1234_set_ramp_delay(struct regulator_dev *rdev,
 				  BUCK_RAMPRATE_MASK, ramp_value << 6);
 }
 
-/* Bucks 1 to 4 support DVS. PWM mode is used when voltage is changed.
+/*
+ * On BD71837 (not on BD71847, BD71850, ...)
+ * Bucks 1 to 4 support DVS. PWM mode is used when voltage is changed.
  * Bucks 5 to 8 and LDOs can use PFM and must be disabled when voltage
  * is changed. Hence we return -EBUSY for these if voltage is changed
  * when BUCK/LDO is enabled.
+ *
+ * The LDO operation for BD71847 and BD71850 is icurrently unknown.
+ * It's safer to still assume they can't be changed when enabled.
  */
 static int bd718xx_set_voltage_sel_restricted(struct regulator_dev *rdev,
 						    unsigned int sel)
@@ -88,6 +93,16 @@ static const struct regulator_ops bd718xx_pickable_range_ldo_ops = {
 };
 
 static const struct regulator_ops bd718xx_pickable_range_buck_ops = {
+	.enable = regulator_enable_regmap,
+	.disable = regulator_disable_regmap,
+	.is_enabled = regulator_is_enabled_regmap,
+	.list_voltage = regulator_list_voltage_pickable_linear_range,
+	.set_voltage_sel = regulator_set_voltage_sel_pickable_regmap,
+	.get_voltage_sel = regulator_get_voltage_sel_pickable_regmap,
+	.set_voltage_time_sel = regulator_set_voltage_time_sel,
+};
+
+static const struct regulator_ops bd71837_pickable_range_buck_ops = {
 	.enable = regulator_enable_regmap,
 	.disable = regulator_disable_regmap,
 	.is_enabled = regulator_is_enabled_regmap,
@@ -116,6 +131,16 @@ static const struct regulator_ops bd718xx_ldo_regulator_nolinear_ops = {
 };
 
 static const struct regulator_ops bd718xx_buck_regulator_ops = {
+	.enable = regulator_enable_regmap,
+	.disable = regulator_disable_regmap,
+	.is_enabled = regulator_is_enabled_regmap,
+	.list_voltage = regulator_list_voltage_linear_range,
+	.set_voltage_sel = regulator_set_voltage_sel_regmap,
+	.get_voltage_sel = regulator_get_voltage_sel_regmap,
+	.set_voltage_time_sel = regulator_set_voltage_time_sel,
+};
+
+static const struct regulator_ops bd71837_buck_regulator_ops = {
 	.enable = regulator_enable_regmap,
 	.disable = regulator_disable_regmap,
 	.is_enabled = regulator_is_enabled_regmap,
@@ -126,6 +151,17 @@ static const struct regulator_ops bd718xx_buck_regulator_ops = {
 };
 
 static const struct regulator_ops bd718xx_buck_regulator_nolinear_ops = {
+	.enable = regulator_enable_regmap,
+	.disable = regulator_disable_regmap,
+	.is_enabled = regulator_is_enabled_regmap,
+	.list_voltage = regulator_list_voltage_table,
+	.map_voltage = regulator_map_voltage_ascend,
+	.set_voltage_sel = regulator_set_voltage_sel_regmap,
+	.get_voltage_sel = regulator_get_voltage_sel_regmap,
+	.set_voltage_time_sel = regulator_set_voltage_time_sel,
+};
+
+static const struct regulator_ops bd71837_buck_regulator_nolinear_ops = {
 	.enable = regulator_enable_regmap,
 	.disable = regulator_disable_regmap,
 	.is_enabled = regulator_is_enabled_regmap,
@@ -805,7 +841,7 @@ static const struct bd718xx_regulator_data bd71837_regulators[] = {
 			.of_match = of_match_ptr("BUCK5"),
 			.regulators_node = of_match_ptr("regulators"),
 			.id = BD718XX_BUCK5,
-			.ops = &bd718xx_pickable_range_buck_ops,
+			.ops = &bd71837_pickable_range_buck_ops,
 			.type = REGULATOR_VOLTAGE,
 			.n_voltages = BD71837_BUCK5_VOLTAGE_NUM,
 			.linear_ranges = bd71837_buck5_volts,
@@ -832,7 +868,7 @@ static const struct bd718xx_regulator_data bd71837_regulators[] = {
 			.of_match = of_match_ptr("BUCK6"),
 			.regulators_node = of_match_ptr("regulators"),
 			.id = BD718XX_BUCK6,
-			.ops = &bd718xx_buck_regulator_ops,
+			.ops = &bd71837_buck_regulator_ops,
 			.type = REGULATOR_VOLTAGE,
 			.n_voltages = BD71837_BUCK6_VOLTAGE_NUM,
 			.linear_ranges = bd71837_buck6_volts,
@@ -856,7 +892,7 @@ static const struct bd718xx_regulator_data bd71837_regulators[] = {
 			.of_match = of_match_ptr("BUCK7"),
 			.regulators_node = of_match_ptr("regulators"),
 			.id = BD718XX_BUCK7,
-			.ops = &bd718xx_buck_regulator_nolinear_ops,
+			.ops = &bd71837_buck_regulator_nolinear_ops,
 			.type = REGULATOR_VOLTAGE,
 			.volt_table = &bd718xx_3rd_nodvs_buck_volts[0],
 			.n_voltages = ARRAY_SIZE(bd718xx_3rd_nodvs_buck_volts),
@@ -878,7 +914,7 @@ static const struct bd718xx_regulator_data bd71837_regulators[] = {
 			.of_match = of_match_ptr("BUCK8"),
 			.regulators_node = of_match_ptr("regulators"),
 			.id = BD718XX_BUCK8,
-			.ops = &bd718xx_buck_regulator_ops,
+			.ops = &bd71837_buck_regulator_ops,
 			.type = REGULATOR_VOLTAGE,
 			.n_voltages = BD718XX_4TH_NODVS_BUCK_VOLTAGE_NUM,
 			.linear_ranges = bd718xx_4th_nodvs_buck_volts,