Commit f15bb6dd authored by Sasha Neftin's avatar Sasha Neftin Committed by Jeff Kirsher

e1000e: Add support for S0ix

Implement flow for S0ix support. Modern SoCs support S0ix low power
states during idle periods, which are sub-states of ACPI S0 that increase
power saving while supporting an instant-on experience for providing
lower latency that ACPI S0. The S0ix states shut off parts of the SoC
when they are not in use, while still maintaning optimal performance.
This patch add support for S0ix started from an Ice Lake platform.
Suggested-by: default avatar"Rafael J. Wysocki" <rafael.j.wysocki@intel.com>
Signed-off-by: default avatarVitaly Lifshits <vitaly.lifshits@intel.com>
Signed-off-by: default avatarRajneesh Bhardwaj <rajneesh.bhardwaj@linux.intel.com>
Signed-off-by: default avatarSasha Neftin <sasha.neftin@intel.com>
Tested-by: default avatarAaron Brown <aaron.f.brown@intel.com>
Signed-off-by: default avatarJeff Kirsher <jeffrey.t.kirsher@intel.com>
parent 0ac960a8
......@@ -6294,6 +6294,174 @@ static void e1000e_flush_lpic(struct pci_dev *pdev)
pm_runtime_put_sync(netdev->dev.parent);
}
/* S0ix implementation */
static void e1000e_s0ix_entry_flow(struct e1000_adapter *adapter)
{
struct e1000_hw *hw = &adapter->hw;
u32 mac_data;
u16 phy_data;
/* Disable the periodic inband message,
* don't request PCIe clock in K1 page770_17[10:9] = 10b
*/
e1e_rphy(hw, HV_PM_CTRL, &phy_data);
phy_data &= ~HV_PM_CTRL_K1_CLK_REQ;
phy_data |= BIT(10);
e1e_wphy(hw, HV_PM_CTRL, phy_data);
/* Make sure we don't exit K1 every time a new packet arrives
* 772_29[5] = 1 CS_Mode_Stay_In_K1
*/
e1e_rphy(hw, I217_CGFREG, &phy_data);
phy_data |= BIT(5);
e1e_wphy(hw, I217_CGFREG, phy_data);
/* Change the MAC/PHY interface to SMBus
* Force the SMBus in PHY page769_23[0] = 1
* Force the SMBus in MAC CTRL_EXT[11] = 1
*/
e1e_rphy(hw, CV_SMB_CTRL, &phy_data);
phy_data |= CV_SMB_CTRL_FORCE_SMBUS;
e1e_wphy(hw, CV_SMB_CTRL, phy_data);
mac_data = er32(CTRL_EXT);
mac_data |= E1000_CTRL_EXT_FORCE_SMBUS;
ew32(CTRL_EXT, mac_data);
/* DFT control: PHY bit: page769_20[0] = 1
* Gate PPW via EXTCNF_CTRL - set 0x0F00[7] = 1
*/
e1e_rphy(hw, I82579_DFT_CTRL, &phy_data);
phy_data |= BIT(0);
e1e_wphy(hw, I82579_DFT_CTRL, phy_data);
mac_data = er32(EXTCNF_CTRL);
mac_data |= E1000_EXTCNF_CTRL_GATE_PHY_CFG;
ew32(EXTCNF_CTRL, mac_data);
/* Check MAC Tx/Rx packet buffer pointers.
* Reset MAC Tx/Rx packet buffer pointers to suppress any
* pending traffic indication that would prevent power gating.
*/
mac_data = er32(TDFH);
if (mac_data)
ew32(TDFH, 0);
mac_data = er32(TDFT);
if (mac_data)
ew32(TDFT, 0);
mac_data = er32(TDFHS);
if (mac_data)
ew32(TDFHS, 0);
mac_data = er32(TDFTS);
if (mac_data)
ew32(TDFTS, 0);
mac_data = er32(TDFPC);
if (mac_data)
ew32(TDFPC, 0);
mac_data = er32(RDFH);
if (mac_data)
ew32(RDFH, 0);
mac_data = er32(RDFT);
if (mac_data)
ew32(RDFT, 0);
mac_data = er32(RDFHS);
if (mac_data)
ew32(RDFHS, 0);
mac_data = er32(RDFTS);
if (mac_data)
ew32(RDFTS, 0);
mac_data = er32(RDFPC);
if (mac_data)
ew32(RDFPC, 0);
/* Enable the Dynamic Power Gating in the MAC */
mac_data = er32(FEXTNVM7);
mac_data |= BIT(22);
ew32(FEXTNVM7, mac_data);
/* Disable the time synchronization clock */
mac_data = er32(FEXTNVM7);
mac_data |= BIT(31);
mac_data &= ~BIT(0);
ew32(FEXTNVM7, mac_data);
/* Dynamic Power Gating Enable */
mac_data = er32(CTRL_EXT);
mac_data |= BIT(3);
ew32(CTRL_EXT, mac_data);
/* Enable the Dynamic Clock Gating in the DMA and MAC */
mac_data = er32(CTRL_EXT);
mac_data |= E1000_CTRL_EXT_DMA_DYN_CLK_EN;
ew32(CTRL_EXT, mac_data);
/* No MAC DPG gating SLP_S0 in modern standby
* Switch the logic of the lanphypc to use PMC counter
*/
mac_data = er32(FEXTNVM5);
mac_data |= BIT(7);
ew32(FEXTNVM5, mac_data);
}
static void e1000e_s0ix_exit_flow(struct e1000_adapter *adapter)
{
struct e1000_hw *hw = &adapter->hw;
u32 mac_data;
u16 phy_data;
/* Disable the Dynamic Power Gating in the MAC */
mac_data = er32(FEXTNVM7);
mac_data &= 0xFFBFFFFF;
ew32(FEXTNVM7, mac_data);
/* Enable the time synchronization clock */
mac_data = er32(FEXTNVM7);
mac_data |= BIT(0);
ew32(FEXTNVM7, mac_data);
/* Disable Dynamic Power Gating */
mac_data = er32(CTRL_EXT);
mac_data &= 0xFFFFFFF7;
ew32(CTRL_EXT, mac_data);
/* Disable the Dynamic Clock Gating in the DMA and MAC */
mac_data = er32(CTRL_EXT);
mac_data &= 0xFFF7FFFF;
ew32(CTRL_EXT, mac_data);
/* Revert the lanphypc logic to use the internal Gbe counter
* and not the PMC counter
*/
mac_data = er32(FEXTNVM5);
mac_data &= 0xFFFFFF7F;
ew32(FEXTNVM5, mac_data);
/* Enable the periodic inband message,
* Request PCIe clock in K1 page770_17[10:9] =01b
*/
e1e_rphy(hw, HV_PM_CTRL, &phy_data);
phy_data &= 0xFBFF;
phy_data |= HV_PM_CTRL_K1_CLK_REQ;
e1e_wphy(hw, HV_PM_CTRL, phy_data);
/* Return back configuration
* 772_29[5] = 0 CS_Mode_Stay_In_K1
*/
e1e_rphy(hw, I217_CGFREG, &phy_data);
phy_data &= 0xFFDF;
e1e_wphy(hw, I217_CGFREG, phy_data);
/* Change the MAC/PHY interface to Kumeran
* Unforce the SMBus in PHY page769_23[0] = 0
* Unforce the SMBus in MAC CTRL_EXT[11] = 0
*/
e1e_rphy(hw, CV_SMB_CTRL, &phy_data);
phy_data &= ~CV_SMB_CTRL_FORCE_SMBUS;
e1e_wphy(hw, CV_SMB_CTRL, phy_data);
mac_data = er32(CTRL_EXT);
mac_data &= ~E1000_CTRL_EXT_FORCE_SMBUS;
ew32(CTRL_EXT, mac_data);
}
static int e1000e_pm_freeze(struct device *dev)
{
struct net_device *netdev = dev_get_drvdata(dev);
......@@ -6649,7 +6817,10 @@ static int e1000e_pm_thaw(struct device *dev)
static int e1000e_pm_suspend(struct device *dev)
{
struct net_device *netdev = pci_get_drvdata(to_pci_dev(dev));
struct e1000_adapter *adapter = netdev_priv(netdev);
struct pci_dev *pdev = to_pci_dev(dev);
struct e1000_hw *hw = &adapter->hw;
int rc;
e1000e_flush_lpic(pdev);
......@@ -6660,14 +6831,25 @@ static int e1000e_pm_suspend(struct device *dev)
if (rc)
e1000e_pm_thaw(dev);
/* Introduce S0ix implementation */
if (hw->mac.type >= e1000_pch_cnp)
e1000e_s0ix_entry_flow(adapter);
return rc;
}
static int e1000e_pm_resume(struct device *dev)
{
struct net_device *netdev = pci_get_drvdata(to_pci_dev(dev));
struct e1000_adapter *adapter = netdev_priv(netdev);
struct pci_dev *pdev = to_pci_dev(dev);
struct e1000_hw *hw = &adapter->hw;
int rc;
/* Introduce S0ix implementation */
if (hw->mac.type >= e1000_pch_cnp)
e1000e_s0ix_exit_flow(adapter);
rc = __e1000_resume(pdev);
if (rc)
return rc;
......
......@@ -18,6 +18,7 @@
#define E1000_FEXTNVM 0x00028 /* Future Extended NVM - RW */
#define E1000_FEXTNVM3 0x0003C /* Future Extended NVM 3 - RW */
#define E1000_FEXTNVM4 0x00024 /* Future Extended NVM 4 - RW */
#define E1000_FEXTNVM5 0x00014 /* Future Extended NVM 5 - RW */
#define E1000_FEXTNVM6 0x00010 /* Future Extended NVM 6 - RW */
#define E1000_FEXTNVM7 0x000E4 /* Future Extended NVM 7 - RW */
#define E1000_FEXTNVM9 0x5BB4 /* Future Extended NVM 9 - RW */
......@@ -234,4 +235,7 @@
#define E1000_RXMTRL 0x0B634 /* Time sync Rx EtherType and Msg Type - RW */
#define E1000_RXUDP 0x0B638 /* Time Sync Rx UDP Port - RW */
/* PHY registers */
#define I82579_DFT_CTRL PHY_REG(769, 20)
#endif
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment