watchdog: sbsa: only use 32-bit accessors

SBSA says of the generic watchdog:

  All registers are 32 bits in size and should be accessed using 32-bit
  reads and writes. If an access size other than 32 bits is used then
  the results are IMPLEMENTATION DEFINED.

and for qemu, the implementation will only allow 32-bit accesses
resulting in a synchronous external abort when configuring the watchdog.
Use lo_hi_* accessors rather than a readq/writeq.

Fixes: abd3ac79 ("watchdog: sbsa: Support architecture version 1")
Signed-off-by: Jamie Iles <quic_jiles@quicinc.com>
Reviewed-by: Guenter Roeck <linux@roeck-us.net>
Reviewed-by: Shaokun Zhang <zhangshaokun@hisilicon.com>
Link: https://lore.kernel.org/r/20210903112101.493552-1-quic_jiles@quicinc.comSigned-off-by: Guenter Roeck <linux@roeck-us.net>
Signed-off-by: Wim Van Sebroeck <wim@linux-watchdog.org>

drivers/watchdog/sbsa_gwdt.c

@@ -130,7 +130,7 @@ static u64 sbsa_gwdt_reg_read(struct sbsa_gwdt *gwdt)
 	if (gwdt->version == 0)
 		return readl(gwdt->control_base + SBSA_GWDT_WOR);
 	else
-		return readq(gwdt->control_base + SBSA_GWDT_WOR);
+		return lo_hi_readq(gwdt->control_base + SBSA_GWDT_WOR);
 }
 
 static void sbsa_gwdt_reg_write(u64 val, struct sbsa_gwdt *gwdt)
@@ -138,7 +138,7 @@ static void sbsa_gwdt_reg_write(u64 val, struct sbsa_gwdt *gwdt)
 	if (gwdt->version == 0)
 		writel((u32)val, gwdt->control_base + SBSA_GWDT_WOR);
 	else
-		writeq(val, gwdt->control_base + SBSA_GWDT_WOR);
+		lo_hi_writeq(val, gwdt->control_base + SBSA_GWDT_WOR);
 }
 
 /*