usb: gadget: udc: lpc32xx: properly setup phy interrupts

Only INT_VBUS_VLD is set to generate ATX interrupts on the phy but
INT_SESS_VLD is checked in vbus_work. This leads to cases where
hot-plugging USB doesn't work after boot.
Signed-off-by: Alexandre Belloni <alexandre.belloni@bootlin.com>
Signed-off-by: Felipe Balbi <felipe.balbi@linux.intel.com>

drivers/usb/gadget/udc/lpc32xx_udc.c

@@ -604,11 +604,11 @@ static void isp1301_udc_configure(struct lpc32xx_udc *udc)
 	i2c_smbus_write_byte_data(udc->isp1301_i2c_client,
 		ISP1301_I2C_INTERRUPT_FALLING | ISP1301_I2C_REG_CLEAR_ADDR, ~0);
 	i2c_smbus_write_byte_data(udc->isp1301_i2c_client,
-		ISP1301_I2C_INTERRUPT_FALLING, INT_VBUS_VLD);
+		ISP1301_I2C_INTERRUPT_FALLING, INT_SESS_VLD | INT_VBUS_VLD);
 	i2c_smbus_write_byte_data(udc->isp1301_i2c_client,
 		ISP1301_I2C_INTERRUPT_RISING | ISP1301_I2C_REG_CLEAR_ADDR, ~0);
 	i2c_smbus_write_byte_data(udc->isp1301_i2c_client,
-		ISP1301_I2C_INTERRUPT_RISING, INT_VBUS_VLD);
+		ISP1301_I2C_INTERRUPT_RISING, INT_SESS_VLD | INT_VBUS_VLD);
 
 	dev_info(udc->dev, "ISP1301 Vendor ID  : 0x%04x\n",
 		 i2c_smbus_read_word_data(udc->isp1301_i2c_client, 0x00));