arm64: dts: marvell: add thermal-zone node in cp110 DTSI file

Add a thermal-zone node and fill in all the sensors available in a
cp110 (only one in the thermal IP).
Signed-off-by: Miquel Raynal <miquel.raynal@bootlin.com>
Signed-off-by: Gregory CLEMENT <gregory.clement@bootlin.com>

arch/arm64/boot/dts/marvell/armada-cp110.dtsi

@@ -6,6 +6,7 @@
  */
 
 #include <dt-bindings/interrupt-controller/mvebu-icu.h>
+#include <dt-bindings/thermal/thermal.h>
 
 #include "armada-common.dtsi"
 
@@ -19,6 +20,23 @@ / {
 	 * save one indentation level
 	 */
 	CP110_NAME: CP110_NAME { };
+
+	/*
+	 * CPs only have one sensor in the thermal IC.
+	 *
+	 * The cooling maps are empty as there are no cooling devices.
+	 */
+	thermal-zones {
+		CP110_LABEL(thermal_ic): CP110_NODE_NAME(thermal-ic) {
+			polling-delay-passive = <1000>;
+			polling-delay = <1000>;
+
+			thermal-sensors = <&CP110_LABEL(thermal) 0>;
+
+			trips {	};
+			cooling-maps { };
+		};
+	};
 };
 
 &CP110_NAME {
@@ -211,6 +229,7 @@ CP110_LABEL(syscon1): system-controller@400000 {
 			CP110_LABEL(thermal): thermal-sensor@70 {
 				compatible = "marvell,armada-cp110-thermal";
 				reg = <0x70 0x10>;
+				#thermal-sensor-cells = <1>;
 			};
 		};