arm64: dts: qcom: pm8994: Add RESIN node

Add a RESIN node to support RESIN-connected buttons on some
devices.
Signed-off-by: Konrad Dybcio <konrad.dybcio@somainline.org>
Link: https://lore.kernel.org/r/20210228130831.203765-8-konrad.dybcio@somainline.orgSigned-off-by: Bjorn Andersson <bjorn.andersson@linaro.org>

arch/arm64/boot/dts/qcom/apq8096-db820c.dtsi

@@ -253,6 +253,11 @@ &mmcc {
 	vdd-gfx-supply = <&vdd_gfx>;
 };
 
+&pm8994_resin {
+	status = "okay";
+	linux,code = <KEY_VOLUMEDOWN>;
+};
+
 &tlmm {
 	gpio-line-names =
 		"[SPI0_DOUT]", /* GPIO_0, BLSP1_SPI_MOSI, LSEC pin 14 */
@@ -1034,20 +1039,6 @@ codec {
 	};
 };
 
-&spmi_bus {
-	pmic@0 {
-		pon@800 {
-			resin {
-				compatible = "qcom,pm8941-resin";
-				interrupts = <0x0 0x8 1 IRQ_TYPE_EDGE_BOTH>;
-				debounce = <15625>;
-				bias-pull-up;
-				linux,code = <KEY_VOLUMEDOWN>;
-			};
-		};
-	};
-};
-
 &ufsphy {
 	status = "okay";
 

arch/arm64/boot/dts/qcom/pm8994.dtsi

@@ -45,7 +45,6 @@ rtc@6000 {
 
 		pm8994_pon: pon@800 {
 			compatible = "qcom,pm8916-pon";
-
 			reg = <0x800>;
 			mode-bootloader = <0x2>;
 			mode-recovery = <0x1>;
@@ -58,6 +57,13 @@ pwrkey {
 				linux,code = <KEY_POWER>;
 			};
 
+			pm8994_resin: resin {
+				compatible = "qcom,pm8941-resin";
+				interrupts = <0x0 0x8 1 IRQ_TYPE_EDGE_BOTH>;
+				debounce = <15625>;
+				bias-pull-up;
+				status = "disabled";
+			};
 		};
 
 		pm8994_temp: temp-alarm@2400 {