Commit f78f4107 authored by Jassi Brar's avatar Jassi Brar Committed by David S. Miller

dt-bindings: net: Add DT bindings for Socionext Netsec

This patch adds documentation for Device-Tree bindings for the
Socionext NetSec Controller driver.
Reviewed-by: default avatarRob Herring <robh@kernel.org>
Signed-off-by: default avatarJassi Brar <jaswinder.singh@linaro.org>
Signed-off-by: default avatarArd Biesheuvel <ard.biesheuvel@linaro.org>
Signed-off-by: default avatarDavid S. Miller <davem@davemloft.net>
parent c215dae4
* Socionext NetSec Ethernet Controller IP
Required properties:
- compatible: Should be "socionext,synquacer-netsec"
- reg: Address and length of the control register area, followed by the
address and length of the EEPROM holding the MAC address and
microengine firmware
- interrupts: Should contain ethernet controller interrupt
- clocks: phandle to the PHY reference clock
- clock-names: Should be "phy_ref_clk"
- phy-mode: See ethernet.txt file in the same directory
- phy-handle: See ethernet.txt in the same directory.
- mdio device tree subnode: When the Netsec has a phy connected to its local
mdio, there must be device tree subnode with the following
required properties:
- #address-cells: Must be <1>.
- #size-cells: Must be <0>.
For each phy on the mdio bus, there must be a node with the following
fields:
- compatible: Refer to phy.txt
- reg: phy id used to communicate to phy.
Optional properties: (See ethernet.txt file in the same directory)
- dma-coherent: Boolean property, must only be present if memory
accesses performed by the device are cache coherent.
- local-mac-address: See ethernet.txt in the same directory.
- mac-address: See ethernet.txt in the same directory.
- max-speed: See ethernet.txt in the same directory.
- max-frame-size: See ethernet.txt in the same directory.
Example:
eth0: ethernet@522d0000 {
compatible = "socionext,synquacer-netsec";
reg = <0 0x522d0000 0x0 0x10000>, <0 0x10000000 0x0 0x10000>;
interrupts = <GIC_SPI 176 IRQ_TYPE_LEVEL_HIGH>;
clocks = <&clk_netsec>;
clock-names = "phy_ref_clk";
phy-mode = "rgmii";
max-speed = <1000>;
max-frame-size = <9000>;
phy-handle = <&phy1>;
mdio {
#address-cells = <1>;
#size-cells = <0>;
phy1: ethernet-phy@1 {
compatible = "ethernet-phy-ieee802.3-c22";
reg = <1>;
};
};
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment