drm/ingenic: Remove bogus register write

Commit 1bdb542d ("drm/ingenic: Simplify code by using hwdescs
array") caused the dma_hwdesc_phys_f{0,1} variables to be used while
uninitialized in a mmio register write, which most certainly broke the
ingenic-drm driver.

However, the very same patchset also submitted commit 60554662
("drm/ingenic: Upload palette before frame"), which restored a correct
behaviour by doing the register writes in a different place in the code.

What's left of this, is just to remove the bogus register writes in the
probe function.
Signed-off-by: Paul Cercueil <paul@crapouillou.net>
Reported-by: kernel test robot <lkp@intel.com>
Link: https://patchwork.freedesktop.org/patch/msgid/20211030100032.42066-1-paul@crapouillou.netAcked-by: Sam Ravnborg <sam@ravnborg.org>

drivers/gpu/drm/ingenic/ingenic-drm-drv.c

@@ -1013,7 +1013,6 @@ static int ingenic_drm_bind(struct device *dev, bool has_components)
 	void __iomem *base;
 	long parent_rate;
 	unsigned int i, clone_mask = 0;
-	dma_addr_t dma_hwdesc_phys_f0, dma_hwdesc_phys_f1;
 	int ret, irq;
 
 	soc_info = of_device_get_match_data(dev);
@@ -1268,10 +1267,6 @@ static int ingenic_drm_bind(struct device *dev, bool has_components)
 		}
 	}
 
-	/* Set address of our DMA descriptor chain */
-	regmap_write(priv->map, JZ_REG_LCD_DA0, dma_hwdesc_phys_f0);
-	regmap_write(priv->map, JZ_REG_LCD_DA1, dma_hwdesc_phys_f1);
-
 	/* Enable OSD if available */
 	if (soc_info->has_osd)
 		regmap_write(priv->map, JZ_REG_LCD_OSDC, JZ_LCD_OSDC_OSDEN);