spi: sh-msiof: Add reset of registers before starting transfer

In accordance with hardware specification Ver 1.0, reset register
transmission / reception setting before transfer.
Signed-off-by: Hiromitsu Yamasaki <hiromitsu.yamasaki.ym@renesas.com>
[geert: Use readl_poll_timeout_atomic()]
Signed-off-by: Geert Uytterhoeven <geert+renesas@glider.be>
Reviewed-by: Wolfram Sang <wsa+renesas@sang-engineering.com>
Signed-off-by: Mark Brown <broonie@kernel.org>

drivers/spi/spi-sh-msiof.c

@@ -132,6 +132,8 @@ struct sh_msiof_spi_priv {
 #define CTR_TFSE	BIT(14)   /* Transmit Frame Sync Signal Output Enable */
 #define CTR_TXE		BIT(9)    /* Transmit Enable */
 #define CTR_RXE		BIT(8)    /* Receive Enable */
+#define CTR_TXRST	BIT(1)    /* Transmit Reset */
+#define CTR_RXRST	BIT(0)    /* Receive Reset */
 
 /* FCTR */
 #define FCTR_TFWM_MASK	GENMASK(31, 29) /* Transmit FIFO Watermark */
@@ -241,6 +243,19 @@ static irqreturn_t sh_msiof_spi_irq(int irq, void *data)
 	return IRQ_HANDLED;
 }
 
+static void sh_msiof_spi_reset_regs(struct sh_msiof_spi_priv *p)
+{
+	u32 mask = CTR_TXRST | CTR_RXRST;
+	u32 data;
+
+	data = sh_msiof_read(p, CTR);
+	data |= mask;
+	sh_msiof_write(p, CTR, data);
+
+	readl_poll_timeout_atomic(p->mapbase + CTR, data, !(data & mask), 1,
+				  100);
+}
+
 static const u32 sh_msiof_spi_div_array[] = {
 	SCR_BRDV_DIV_1, SCR_BRDV_DIV_2,	 SCR_BRDV_DIV_4,
 	SCR_BRDV_DIV_8,	SCR_BRDV_DIV_16, SCR_BRDV_DIV_32,
@@ -920,6 +935,9 @@ static int sh_msiof_transfer_one(struct spi_controller *ctlr,
 	bool swab;
 	int ret;
 
+	/* reset registers */
+	sh_msiof_spi_reset_regs(p);
+
 	/* setup clocks (clock already enabled in chipselect()) */
 	if (!spi_controller_is_slave(p->ctlr))
 		sh_msiof_spi_set_clk_regs(p, clk_get_rate(p->clk), t->speed_hz);