The seq_open_net() call should be accompanied with seq_release_net() one.
Signed-off-by: Pavel Emelyanov <xemul@openvz.org>
Signed-off-by: Patrick McHardy <kaber@trash.net>
Signed-off-by: David S. Miller <davem@davemloft.net>

if tcphoff remains unsigned, a negative ipv6_skip_exthdr() return value will
go unnoticed,
Signed-off-by: Roel Kluin <12o3l@tiscali.nl>
Signed-off-by: Patrick McHardy <kaber@trash.net>
Signed-off-by: David S. Miller <davem@davemloft.net>

This fixes inappropriately large cwnd growth on sender-limited flows
when GSO is enabled, limiting cwnd growth to 64k.
Signed-off-by: John Heffner <johnwheffner@gmail.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

This changes the logic in tcp_is_cwnd_limited() so that cwnd may grow
up to tcp_max_burst() even when sk_can_gso() is false, or when
sysctl_tcp_tso_win_divisor != 0.
Signed-off-by: John Heffner <johnwheffner@gmail.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

TBIPA needs to be set to a value (on connected MDIO buses) that
doesn't conflict with PHYs on the bus.  By hardcoding it to 0x1f,
we were preventing boards with PHYs at 0x1f from working properly.
Instead, scan the bus when it comes up, and find an address that
doesn't have a PHY on it.  The TBI PHY configuration code then
trusts that the value in TBIPA is either safe, or doesn't matter
(ie - it's not an active bus with other PHYs).
Signed-off-by: Andy Fleming <afleming@freescale.com>
Signed-off-by: Paul Gortmaker <paul.gortmaker@windriver.com>
Signed-off-by: Jeff Garzik <jgarzik@redhat.com>

Adds a driver for built-in IXP4xx Ethernet ports.
Signed-off-by: Krzysztof Hałasa <khc@pm.waw.pl>
Signed-off-by: Jeff Garzik <jgarzik@redhat.com>

dev->irq is unsigned, platform_get_irq() may return signed unnoticed
Signed-off-by: Roel Kluin <12o3l@tiscali.nl>
Signed-off-by: Jeff Garzik <jgarzik@redhat.com>

Signed-off-by: Cornelia Huck <cornelia.huck@de.ibm.com>
Signed-off-by: Frank Blaschka <frank.blaschka@de.ibm.com>
Signed-off-by: Jeff Garzik <jgarzik@redhat.com>

Allow ethtool to turn on/off EDDP via ethtool TSO interface.
Signed-off-by: Frank Blaschka <frank.blaschka@de.ibm.com>
Signed-off-by: Jeff Garzik <jgarzik@redhat.com>

Read out number of ports from the hardware.
Signed-off-by: Ursula Braun <braunu@de.ibm.com>
Signed-off-by: Frank Blaschka <frank.blaschka@de.ibm.com>
Signed-off-by: Jeff Garzik <jgarzik@redhat.com>

In case the ccwgroup device is set online/offline we have to run
the corresponding dev_open/close for the netdevice.
Signed-off-by: Frank Blaschka <frank.blaschka@de.ibm.com>
Signed-off-by: Jeff Garzik <jgarzik@redhat.com>

Remove unnecessary traces. Remove unnecessary wrappers for skb
functions.
Signed-off-by: Frank Blaschka <frank.blaschka@de.ibm.com>
Signed-off-by: Jeff Garzik <jgarzik@redhat.com>

Load balancing bonding queries the speed of the slave interfaces.
To support a bond consisting of different slave speeds we have to
report the speed by ethtool settings.
Signed-off-by: Frank Blaschka <frank.blaschka@de.ibm.com>
Signed-off-by: Jeff Garzik <jgarzik@redhat.com>

hiper socket require the QETH_HDR_EXT_VLAN_FRAME flag in the
qdio header to handle vlan tagged frames.
Signed-off-by: Frank Blaschka <frank.blaschka@de.ibm.com>
Signed-off-by: Jeff Garzik <jgarzik@redhat.com>

Replace complex macro for s390dbf calls by equivalent function. This reduces
module size about 10% without visible performance impact.
Signed-off-by: Peter Tiedemann <ptiedem@de.ibm.com>
Signed-off-by: Frank Blaschka <frank.blaschka@de.ibm.com>
Signed-off-by: Jeff Garzik <jgarzik@redhat.com>

Instead of having each driver for ccwgroup slave device parsing the
input itself and calling ccwgroup_create(), introduce a new function
ccwgroup_create_from_string() and handle parsing inside the ccwgroup
core.
Signed-off-by: Ursula Braun <braunu@de.ibm.com>
Signed-off-by: Frank Blaschka <frank.blaschka@de.ibm.com>
Signed-off-by: Jeff Garzik <jgarzik@redhat.com>

There is no urgent need to restart a netiucv connection automatically,
if packets are sent while the netiucv device is not up and running.
Signed-off-by: Ursula Braun <braunu@de.ibm.com>
Signed-off-by: Frank Blaschka <frank.blaschka@de.ibm.com>
Signed-off-by: Jeff Garzik <jgarzik@redhat.com>

Sequence numbers in skbs (Receive path) are assigned only to
802.2 packets.
Signed-off-by: Klaus D. Wacker <kdwacker@de.ibm.com>
Signed-off-by: Frank Blaschka <frank.blaschka@de.ibm.com>
Signed-off-by: Jeff Garzik <jgarzik@redhat.com>

Signed-off-by: Bryan Wu <cooloney@kernel.org>
Signed-off-by: Jeff Garzik <jgarzik@redhat.com>

 - replace specific "bf537" function or data structure name to "bfin_mac"
 - cleanup bfin_mac_probe with error checking
 - punt set_pin_mux function, call peripheral request/free list functions directly
Signed-off-by: Bryan Wu <cooloney@kernel.org>
Signed-off-by: Jeff Garzik <jgarzik@redhat.com>

Found by sparse dubious !x & y warning...hidden in the GetBit macro
why !Word doesn't make any sense.
Signed-off-by: Harvey Harrison <harvey.harrison@gmail.com>
Signed-off-by: Jeff Garzik <jgarzik@redhat.com>

Add support for two additional SMSC PHY models with identical interrupt
source and mask registers to the LAN83C185
Signed-off-by: Steve Glendinning <steve.glendinning@smsc.com>
Signed-off-by: Jeff Garzik <jgarzik@redhat.com>

Several models of SMSC PHY have the same interrupt status and mask
registers as the LAN83C185, so these functions can service multiple
different PHY drivers.
Signed-off-by: Steve Glendinning <steve.glendinning@smsc.com>
Signed-off-by: Jeff Garzik <jgarzik@redhat.com>

Fix kernel-doc warning:
Warning(linux-2.6.25-git11//drivers/net/phy/phy_device.c:275): No
description found for parameter 'bus_id'
Signed-off-by: Randy Dunlap <randy.dunlap@oracle.com>
Signed-off-by: Jeff Garzik <jgarzik@redhat.com>

- Updated version number.
Signed-off-by: Surjit Reang <surjit.reang@neterion.com>
Signed-off-by: Sreenivasa Honnur <sreenivasa.honnur@neterion.com>
Signed-off-by: Ramkrishna Vepa <ram.vepa@neterion.com>
Signed-off-by: Jeff Garzik <jgarzik@redhat.com>

	- Seperate ring specific data
	- Initialize all configured rings with equal priority.
	- Updated boundary check for number of Rings.
	- Updated per ring statistics of rx_bytes and rx_packets.
	- Moved lro struct from struct s2io_nic to struct ring_info.
	- Access respective rx ring directly in fill_rx_buffers.
	- Moved rx_bufs_left struct s2io_nic to struct ring_info.
	- Added per ring variables -  rxd_mode, rxd_count, dev, pdev.
Signed-off-by: Surjit Reang <surjit.reang@neterion.com>
Signed-off-by: Sreenivasa Honnur <sreenivasa.honnur@neterion.com>
Signed-off-by: Ramkrishna Vepa <ram.vepa@neterion.com>
Signed-off-by: Jeff Garzik <jgarzik@redhat.com>

Use net_device_stats from net_device structure instead of local.
Signed-off-by: Paulius Zaleckas <paulius.zaleckas@teltonika.lt>
Signed-off-by: Jeff Garzik <jgarzik@redhat.com>

Use net_device_stats from net_device structure instead of local.
Signed-off-by: Paulius Zaleckas <paulius.zaleckas@teltonika.lt>
Signed-off-by: Jeff Garzik <jgarzik@redhat.com>

Use net_device_stats from net_device structure instead of local.
No need to memset it to 0, because it is allocated by kzalloc.
Signed-off-by: Paulius Zaleckas <paulius.zaleckas@teltonika.lt>
Signed-off-by: Jeff Garzik <jgarzik@redhat.com>

Merge branch 'upstream-jeff' of git://git.kernel.org/pub/scm/linux/kernel/git/romieu/netdev-2.6 into upstream

Merge branch 'sis190' of git://git.kernel.org/pub/scm/linux/kernel/git/romieu/netdev-2.6 into upstream

The driver supports the 10Xpress PHY and XFP modules on our reference
designs SFE4001 and SFE4002 and the SMC models SMC10GPCIe-XFP and
SMC10GPCIe-10BT.
Signed-off-by: Ben Hutchings <bhutchings@solarflare.com>
Signed-off-by: Jeff Garzik <jgarzik@redhat.com>

If IWL3945 ever depends on IWLCORE, the silent, user-invisible
IWLWIFI option can go away.
Signed-off-by: Jason Riedy <jason@acm.org>
Signed-off-by: David S. Miller <davem@davemloft.net>

Fix build error caused by commit
e82404ad ("iwlwifi: Select
LEDS_CLASS.") from David Miller:

Since MAC80211_LEDS is selected by wireless drivers it must select its
own dependencies otherwise a build error may occur (kbuild will select
the symbol regardless of "depends" constraints).
Signed-off-By: Luca Tettamanti <kronos.it@gmail.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

From: Evgeniy Polyakov <johnpol@2ka.mipt.ru>

This fixes a regression added by ec3c0982
("[TCP]: TCP_DEFER_ACCEPT updates - process as established")

tcp_v6_do_rcv()->tcp_rcv_established(), the latter goes to step5, where
eventually skb can be freed via tcp_data_queue() (drop: label), then if
check for tcp_defer_accept_check() returns true and thus
tcp_rcv_established() returns -1, which forces tcp_v6_do_rcv() to jump
to reset: label, which in turn will pass through discard: label and free
the same skb again.

Tested by Eric Sesterhenn.
Signed-off-by: David S. Miller <davem@davemloft.net>
Acked-By: Patrick McManus <mcmanus@ducksong.com>

Add support on 64-bit kernels for seting 32-bit compatible MCAST*
socket options.
Signed-off-by: David L Stevens <dlstevens@us.ibm.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

Previously digest_null had no setkey function which meant that
we used hmac(digest_null) for IPsec since IPsec always calls
setkey.  Now that digest_null has a setkey we no longer need to
do that.

In fact when only confidentiality is specified for ESP we already
use digest_null directly.  However, when the null algorithm is
explicitly specified by the user we still opt for hmac(digest_null).

This patch removes this discrepancy.  I have not added a new compat
name for it because by chance it wasn't actualy possible for the user
to specify the name hmac(digest_null) due to a key length check in
xfrm_user (which I found out when testing that compat name :)
Signed-off-by: Herbert Xu <herbert@gondor.apana.org.au>
Signed-off-by: David S. Miller <davem@davemloft.net>

Fix missing sunrpc kernel-doc:

Warning(linux-2.6.25-git7//net/sunrpc/xprt.c:451): No description found for parameter 'action'
Signed-off-by: Randy Dunlap <randy.dunlap@oracle.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

Both copy_to_ and _from_user return the number of bytes, that failed to
reach their destination, not the 0/-EXXX values.

Based on patch from Pavel Emelyanov <xemul@openvz.org>
Signed-off-by: Sam Ravnborg <sam@ravnborg.org>
Acked-by: Oliver Hartkopp <oliver.hartkopp@volkswagen.de>
Signed-off-by: David S. Miller <davem@davemloft.net>

This reverts commit 5b3f129c.

As requested by Maciej W. Rozycki.
Signed-off-by: David S. Miller <davem@davemloft.net>