Make acpi_load_table() available for use by removing it from the #ifdef
ACPI_FUTURE_USAGE.

Also add a new routine used to unload an ACPI table of a given type and "id" -
acpi_unload_table_id().  The implementation of this new routine was almost a
direct copy of existing routine acpi_unload_table() - only difference being
that it only removes a specific table id instead of ALL tables of a given
type.  The SN hotplug driver (sgi_hotplug.c) now uses both of these interfaces
to dynamically load and unload SSDT ACPI tables.

Also, a few other ACPI routines now used by the SN hotplug driver are exported
(since the driver can be a loadable module):

 acpi_ns_map_handle_to_node
 acpi_ns_convert_entry_to_handle
 acpi_ns_get_next_node
Signed-off-by: Aaron Young <ayoung@sgi.com>
Cc: Greg KH <greg@kroah.com>
Cc: "Luck, Tony" <tony.luck@intel.com>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Len Brown <len.brown@intel.com>

* 'for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/jikos/hid:
  [PATCH] Generic HID layer - update MAINTAINERS
  input/hid: Supporting more keys from the HUT Consumer Page
  [PATCH] Generic HID layer - build: USB_HID should select HID

Signed-off-by: Evgeniy Polyakov <johnpol@2ka.mipt.ru>
Signed-off-by: David S. Miller <davem@davemloft.net>

Fix the redirect packet of the router if the jiffies wraparound.
Signed-off-by: Li Yewang <lyw@nanjing-fnst.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

The message logged in tcp_v4_inbound_md5_hash when the hash was expected
but not found was reversed.
Signed-off-by: Leigh Brown <leigh@solinno.co.uk>
Signed-off-by: David S. Miller <davem@davemloft.net>

md5sig_info.alloced4 must be set to zero when freeing keys4, otherwise
it will not be alloc'd again when another key is added to the same
socket by tcp_v4_md5_do_add.
Signed-off-by: Leigh Brown <leigh@solinno.co.uk>
Signed-off-by: David S. Miller <davem@davemloft.net>

Linus has changed work queue structure and has not tested it with
connector compiled in, his changes break the build.

Attached patch fixes compilation error.

Patch is against commit 99f5e971.

Thanks to Toralf Förster for pointing this out.
Signed-off-by: Evgeniy Polyakov <johnpol@2ka.mipt.ru>
Signed-off-by: David S. Miller <davem@davemloft.net>

Update version to 3.71.
Signed-off-by: Michael Chan <mchan@broadcom.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

The 5906 PHY requires a special register bit to power down and up the
PHY.
Signed-off-by: Michael Chan <mchan@broadcom.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

Hot-plug scripts can call tg3_open() as soon as register_netdev() is
called in tg3_init_one().  We need to call pci_set_drvdata() before
register_netdev(), and netif_carrier_off() needs to be moved to
tg3_open() to avoid race conditions.
Signed-off-by: Michael Chan <mchan@broadcom.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

tp->link_config.orig_* values must be assigned during
tg3_set_settings() because these values will be used to setup the
link speed during tg3_open().  Without these assignments, the link
speed settings will be all messed by if tg3_set_settings() is called
when the device is down.
Signed-off-by: Michael Chan <mchan@broadcom.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

Although the menu dependencies in net/ipv6/netfilter/Kconfig
guard the entries in that file from the Kconfig GUI, this does
not prevent them from being selected still via "make oldconfig"
when IPV6 etc. is disabled.

So add explicit dependencies.
Signed-off-by: David S. Miller <davem@davemloft.net>

Use the configured MAC address instead of the permanent MAC address
for loopback frames.

Update version to 1.5.2.
Signed-off-by: Michael Chan <mchan@broadcom.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

Length was not calculated correctly if the NVRAM offset is on a non-
aligned offset.
Signed-off-by: Michael Chan <mchan@broadcom.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

There was an off-by-one bug in bnx2_tx_avail().  If the tx ring is
completely full, the producer and consumer indices may be apart by
256 even though the ring size is only 255.  One entry in the ring is
unused and must be properly accounted for when calculating the number
of available entries.  The bug caused the tx ring entries to be
reused by mistake, overwriting active entries, and ultimately causing
it to crash.

This bug rarely occurs because the tx ring is rarely completely full.
We always stop when there is less than MAX_SKB_FRAGS entries available
in the ring.

Thanks to Corey Kovacs <cjk@techma.com> and Andy Gospodarek
<agospoda@redhat.com> for reporting the problem and helping to collect
debug information.
Signed-off-by: Michael Chan <mchan@broadcom.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

rose_add_loopback_neigh uses kmalloc and the callers were ignoring the
error value.  Rewrite to let the caller deal with the allocation.  This
allows the use of static allocation of kmalloc use entirely.
Signed-off-by: Ralf Baechle <ralf@linux-mips.org>
Signed-off-by: David S. Miller <davem@davemloft.net>

Signed-off-by: Ralf Baechle <ralf@linux-mips.org>
Signed-off-by: David S. Miller <davem@davemloft.net>

ax25_linkfail_register uses kmalloc and the callers were ignoring the
error value.  Rewrite to let the caller deal with the allocation.  This
allows the use of static allocation of kmalloc use entirely.
Signed-off-by: Ralf Baechle <ralf@linux-mips.org>
Signed-off-by: David S. Miller <davem@davemloft.net>

Signed-off-by: Ralf Baechle <ralf@linux-mips.org>
Signed-off-by: David S. Miller <davem@davemloft.net>

Fix ax25_listen_register to return something that's a sane error code,
then all callers to use it.
Signed-off-by: Ralf Baechle <ralf@linux-mips.org>
Signed-off-by: David S. Miller <davem@davemloft.net>

Replace ax25_protocol_register by ax25_register_pid which assumes the
caller has done the memory allocation.  This allows replacing the
kmalloc allocations entirely by static allocations.
Signed-off-by: Ralf Baechle <ralf@linux-mips.org>
Signed-off-by: David S. Miller <davem@davemloft.net>

The recent fix 0506d406 made obvious that
error values were not being propagated through the AX.25 stack.  To help
with that this patch marks all kmalloc users in the AX.25, NETROM and
ROSE stacks as __must_check.
Signed-off-by: Ralf Baechle <ralf@linux-mips.org>
Signed-off-by: David S. Miller <davem@davemloft.net>

Replace kmalloc+memset with kzalloc
Signed-off-by: Yan Burman <burman.yan@gmail.com>
Acked-by: Michael Chan <mchan@broadcom.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

* master.kernel.org:/pub/scm/linux/kernel/git/davej/cpufreq:
  [CPUFREQ] longhaul compile fix.
  [CPUFREQ] Advise not to use longhaul on VIA C7.
  [CPUFREQ] set policy->curfreq on initialization
  [CPUFREQ] Trivial cleanup for acpi read/write port in acpi-cpufreq.c
  [CPUFREQ] fixes typo in cpufreq.c

Signed-off-by: Al Viro <viro@zeniv.linux.org.uk>
Acked-by: Benjamin Herrenschmidt <benh@kernel.crashing.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

Recent workqueue changes basically make this a formal requirement.

Also, move atomic32.o from lib-y to obj-y since it exports symbols
to modules.
Signed-off-by: David S. Miller <davem@davemloft.net>

Some gcc's are more anal than others about empty switch labels.
error: label at end of compound statement
Signed-off-by: Dave Jones <davej@redhat.com>

C7's are centrino speedstep-alike.
Signed-off-by: Dave Jones <davej@redhat.com>

Check the correct variable and set policy->cur upon acpi-cpufreq
initialization to allow the userspace governor to be used as default.
Signed-off-by: Mattia Dongili <malattia@linux.it>
Acked-by: "Pallipadi, Venkatesh" <venkatesh.pallipadi@intel.com>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Dave Jones <davej@redhat.com>

Signed-off-by: David S. Miller <davem@davemloft.net>

Signed-off-by: David S. Miller <davem@davemloft.net>

"sunkbd_enable(sunkbd, 0);" has no effect. Adding "sunkbd->enabled =
enable" in sunkbd_enable (obvious)
Signed-off-by: Fabrice Knevez <nuxdoors@cegetel.net>
Signed-off-by: David S. Miller <davem@davemloft.net>

desc-status --> desc->status
Signed-off-by: David S. Miller <davem@davemloft.net>

Use struct irq_chip instead of hw_interrupt_type.

Delete hw_resend_irq(), totally unused.
Signed-off-by: David S. Miller <davem@davemloft.net>

It branches around some necessary prom calls, which we would
need to do even if we are mapped at the correct location already.
So it doesn't work.

The idea was that this sort of thing could be used for the eventual
kexec implementation, but it is clear that this will need to be
done differently.
Signed-off-by: David S. Miller <davem@davemloft.net>

fix a typo, sys_mincore() needs min().
Signed-off-by: Oleg Nesterov <oleg@tv-sign.ru>
Signed-off-by: Linus "I'm a moron" Torvalds <torvalds@osdl.org>

amikbd: missing declaration
sun3_NCR5380: more work_struct mess
sun3_NCR5380: cast is not an lvalue
Signed-off-by: Al Viro <viro@zeniv.linux.org.uk>

Hugh Dickins correctly points out that mincore() is actually _supposed_
to fail on an unmapped hole in the user address space, rather than
return valid ("empty") information about the hole.  This just simplifies
the problem further (I had been misled by our previous confusing and
complicated way of doing mincore()).

Also, in the unlikely situation that we can't allocate a temporary
kernel buffer, we should actually return EAGAIN, not ENOMEM, to keep the
"unmapped hole" and "allocation failure" error cases separate.

Finally, add a comment about our stupid historical lack of support for
anonymous mappings.  I'll fix that if somebody reminds me after 2.6.20
is out.
Acked-by: Hugh Dickins <hugh@veritas.com>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

* 'for-linus' of master.kernel.org:/pub/scm/linux/kernel/git/roland/infiniband:
  IB/mthca: Use DEFINE_MUTEX() instead of mutex_init()
  IB/mthca: Add HCA profile module parameters
  IB/srp: Fix FMR mapping for 32-bit kernels and addresses above 4G
  IB: Fix ib_dma_alloc_coherent() wrapper

* 'upstream-linus' of master.kernel.org:/pub/scm/linux/kernel/git/jgarzik/libata-dev:
  [PATCH] pata_via: Cable detect error
  [PATCH] Fix help text for CONFIG_ATA_PIIX
  [PATCH] initializer entry defined twice in pata_rz1000
  [PATCH] ata: fix platform_device_register_simple() error check
  [PATCH] ahci: do not mangle saved HOST_CAP while resetting controller
  [PATCH] libata: don't initialize sg in ata_exec_internal() if DMA_NONE (take #2)
  [libata] sata_svw: Disable ATAPI DMA on current boards (errata workaround)
  [libata] use kmap_atomic(KM_IRQ0) in SCSI simulator
  [PATCH] ata_piix: use piix_host_stop() in ich_pata_ops
  [PATCH] ata_piix: IDE mode SATA patch for Intel ICH9