- 18 Feb, 2009 1 commit
-
-
Hannes Eder authored
Impact: Move variable declaration to a more inner scope. Fix this sparse warning: drivers/net/at1700.c:846:21: warning: symbol 'i' shadows an earlier one drivers/net/at1700.c:831:13: originally declared here Signed-off-by:
Hannes Eder <hannes@hanneseder.net> Signed-off-by:
David S. Miller <davem@davemloft.net>
-
- 16 Feb, 2009 39 commits
-
-
Thomas Gleixner authored
Impact: syntax fix Interestingly enough this compiles w/o any complaints: orphans = percpu_counter_sum_positive(&tcp_orphan_count), sockets = percpu_counter_sum_positive(&tcp_sockets_allocated), Signed-off-by:
Thomas Gleixner <tglx@linutronix.de> Signed-off-by:
-
Vlad Yasevich authored
During peeloff/accept() sctp needs to save the parent socket state into the new socket so that any options set on the parent are inherited by the child socket. This was found when the parent/listener socket issues SO_BINDTODEVICE, but the data was misrouted after a route cache flush. Signed-off-by:
Vlad Yasevich <vladislav.yasevich@hp.com> Signed-off-by:
-
Vlad Yasevich authored
SCTP incorrectly doubles rto ever time a Hearbeat chunk is generated. However RFC 4960 states: On an idle destination address that is allowed to heartbeat, it is recommended that a HEARTBEAT chunk is sent once per RTO of that destination address plus the protocol parameter 'HB.interval', with jittering of +/- 50% of the RTO value, and exponential backoff of the RTO if the previous HEARTBEAT is unanswered. Essentially, of if the heartbean is unacknowledged, do we double the RTO. Signed-off-by:
-
Vlad Yasevich authored
The sctp crc32c checksum is always generated in little endian. So, we clean up the code to treat it as little endian and remove all the __force casts. Suggested by Herbert Xu. Signed-off-by:
-
Lucas Nussbaum authored
This is a new version of my patch, now using a module parameter instead of a sysctl, so that the option is harder to find. Please note that, once the module is loaded, it is still possible to change the value of the parameter in /sys/module/sctp/parameters/, which is useful if you want to do performance comparisons without rebooting. Computation of SCTP checksums significantly affects the performance of SCTP. For example, using two dual-Opteron 246 connected using a Gbe network, it was not possible to achieve more than ~730 Mbps, compared to 941 Mbps after disabling SCTP checksums. Unfortunately, SCTP checksum offloading in NICs is not commonly available (yet). By default, checksums are still enabled, of course. Signed-off-by:
Lucas Nussbaum <lucas.nussbaum@ens-lyon.fr> Signed-off-by:
-
Alexander Duyck authored
Currently the driver uses advanced descriptors for its main functionality, but then uses legacy when testing. This patch changes this so that advanced descriptors are used throughout and all mentions of legacy descriptors are removed. Signed-off-by:
Alexander Duyck <alexander.h.duyck@intel.com> Acked-by:
Peter P Waskiewicz Jr <peter.p.waskiewicz.jr@intel.com> Signed-off-by:
Jeff Kirsher <jeffrey.t.kirsher@intel.com> Signed-off-by:
-
Alexander Duyck authored
This patch removes all of the unused defines from the .h files contained in igb. For some defines there was a use and so I plugged them into the correct locations. Signed-off-by:
-
Alexander Duyck authored
This patch combines a pair of if statements into one. Signed-off-by:
-
Alexander Duyck authored
IP Checksum enable doesn't need packet split in order to function. It only requires the use of advanced descriptors which the current igb driver does. So we can enable it always without any issues. Signed-off-by:
-
Alexander Duyck authored
Update the Adaptive Interrupt Moderation algorithm so that the low latency state is triggered less easily to prevent high interrupt loads. Signed-off-by:
-
Alexander Duyck authored
This patch is intended to hold several whitespace, formatting, and comment cleanups that have been found while cleaning up the igb driver. Signed-off-by:
-
Lennert Buytenhek authored
Controlled by a compile-time (Kconfig) option for now, since it isn't a win in all cases. Signed-off-by:
Lennert Buytenhek <buytenh@marvell.com> Signed-off-by:
-
Lennert Buytenhek authored
Signed-off-by:
-
Lennert Buytenhek authored
Signed-off-by:
-
Lennert Buytenhek authored
Rename the mp->default_[rt]x_ring_size variables to ->[rt]x_ring_size, allow them to be read via the standard ethtool ->get_ringparam() op, and add a ->set_ringparam() op to allow resizing them at run time. Signed-off-by:
-
Lennert Buytenhek authored
This patch: - increases the precision of the receive/transmit interrupt coalescing register value computations by using 64bit temporaries; - adds functions to read the current hardware coalescing register values and convert them back to usecs; - exports the {get,set} {rx,tx} coal methods via the standard ethtool coalescing interface. Signed-off-by: -
Lennert Buytenhek authored
It's a waste having two different versions of this structure around when the differences between ethtool ops for phy'd and phy-less interfaces are so minor. Signed-off-by:
-
Hannes Eder authored
Jiffies are unsigned long, make sure we fit in jiffies store variable on archs with bits per long > 32. Patch suggested by Jiri Slaby. Signed-off-by:
-
Hannes Eder authored
Fix this sparse warnings: drivers/isdn/mISDN/clock.c:44:1: warning: symbol 'iclock_lock' was not declared. Should it be static? drivers/isdn/mISDN/clock.c:45:9: warning: symbol 'iclock_count' was not declared. Should it be static? drivers/isdn/mISDN/clock.c:46:17: warning: symbol 'iclock_tv' was not declared. Should it be static? drivers/isdn/mISDN/clock.c:47:9: warning: symbol 'iclock_tv_valid' was not declared. Should it be static? drivers/isdn/mISDN/clock.c:48:20: warning: symbol 'iclock_current' was not declared. Should it be static? Signed-off-by:
-
Hannes Eder authored
Fix this sparse warnings: drivers/isdn/hardware/mISDN/hfcpci.c:59:19: warning: symbol 'hfc_tl' was not declared. Should it be static? drivers/isdn/hardware/mISDN/hfcpci.c:60:9: warning: symbol 'hfc_jiffies' was not declared. Should it be static? drivers/isdn/hardware/mISDN/hfcsusb.h:201:6: warning: symbol 'conf_str' was not declared. Should it be static? drivers/isdn/hardware/mISDN/hfcsusb.h:319:12: warning: symbol 'HFC_TE_LAYER1_STATES' was not declared. Should it be static? drivers/isdn/hardware/mISDN/hfcsusb.h:331:12: warning: symbol 'HFC_NT_LAYER1_STATES' was not declared. Should it be static? drivers/isdn/hardware/mISDN/hfcsusb.c:38:12: warning: symbol 'hfcsusb_rev' was not declared. Should it be static? drivers/isdn/hardware/mISDN/hfcsusb.c:978:1: warning: symbol 'fill_isoc_urb' was not declared. Should it be static? drivers/isdn/hardware/mISDN/hfcsusb.c:1724:1: warning: symbol 'setup_hfcsusb' was not declared. Should it be static? Signed-off-by:
-
Eilon Greenstein authored
And updating the year Signed-off-by:
Eilon Greenstein <eilong@broadcom.com> Signed-off-by:
-
Eilon Greenstein authored
Whitespaces, empty lines, 80 columns, indentations and removing redundant parenthesis Signed-off-by:
-
Eilon Greenstein authored
Signed-off-by:
-
Eilon Greenstein authored
Signed-off-by:
-
Eilon Greenstein authored
Signed-off-by:
-
Eilon Greenstein authored
Re-arrange the driver debug print to support the Tx multi-queue and add support for debug prints at the end of the ring (when start<end) Signed-off-by:
-
Eilon Greenstein authored
Signed-off-by:
Harvey Harrison <harvey.harrison@gmail.com> Signed-off-by:
-
Eilon Greenstein authored
Resolving the majority of the issues, but there are still some left for future patches. Signed-off-by:
-
Eilon Greenstein authored
Signed-off-by:
-
Eilon Greenstein authored
This is the device info from the chip shared memory - rename to avoid confusion Signed-off-by:
-
Eilon Greenstein authored
When loading in diag mode, set the device to loopback instead of normal link and then changing it to loopback mode Signed-off-by:
-
Eilon Greenstein authored
Signed-off-by:
-
Eilon Greenstein authored
Signed-off-by:
-
Eilon Greenstein authored
The driver default WoL setting is set to the nvram default value Signed-off-by:
-
Eilon Greenstein authored
Signed-off-by:
-
Eilon Greenstein authored
When enabling many debug prints, it can take a while before processing an event. To ease the debug process, allow bigger timeout before giving up Signed-off-by:
-
Eilon Greenstein authored
Signed-off-by:
-
Eilon Greenstein authored
Allows better debug capabilities if the user wants to force an MRRS value Signed-off-by:
-
Eilon Greenstein authored
Signed-off-by:
-
