- 21 Nov, 2007 21 commits
-
-
Sonic Zhang authored
Signed-off-by:
Michael Hennerich <michael.hennerich@analog.com> Signed-off-by:
Sonic Zhang <sonic.zhang@analog.com> Signed-off-by:
Bryan Wu <bryan.wu@analog.com>
-
Mike Frysinger authored
Blackfin arch: split apart dump_bfin_regs and merge/remove show_regs from process.c, which was largely duplicated Signed-off-by:
Mike Frysinger <michael.frysinger@analog.com> Signed-off-by:
-
Mike Frysinger authored
Blackfin arch: use common __INIT/__FINIT defines rather than setting the .section ourselves to .init.text Signed-off-by:
-
Robin Getz authored
We need to send signals with the proper PC, or gdb gets confused, and lots of tests fail. This should fix that. Signed-off-by:
Robin Getz <robin.getz@analog.com> Signed-off-by:
-
Robin Getz authored
Signed-off-by:
-
Bernd Schmidt authored
Need to specify "ax" with the .init.text section, otherwise the linker will make unique .init.text.1 .. .init.text.3 sections to cope with the flags
-
Robin Getz authored
Signed-off-by:
-
Mike Frysinger authored
Signed-off-by:
-
Mike Frysinger authored
Signed-off-by:
-
Mike Frysinger authored
Signed-off-by:
-
Mike Frysinger authored
Should not need separate cplb entry though as we cover L1 with a 4 meg page Signed-off-by:
-
Mike Frysinger authored
- remove duplicated defines for the BF561 - generalize L2 support (so that it works for BF54x) and mark it executable - add support for reading/executing the Boot ROM sections (since it has data/functions we may need at runtime) - and fixup names for each map Signed-off-by:
-
Mike Frysinger authored
- no need to declare their sizes in the common header - no need to tack on the section attribute as only the definition matters, not references Signed-off-by:
-
Mike Frysinger authored
Signed-off-by:
-
Mike Frysinger authored
Anomaly 05000312 - Errors When SSYNC, CSYNC, or Loads to LT, LB and LC Registers Are Interrupted: DESCRIPTION: When instruction cache is enabled, erroneous behavior may occur when any of the following instructions are interrupted: . CSYNC • SSYNC • LCx = • LTx = (only when LCx is non-zero) • LBx = (only when LCx is non-zero) When this problem occurs, a variety of incorrect things could happen, including an illegal instruction exception. Additional errors could show up as an exception, a hardware error, or an instruction that is valid but different than the one that was expected. WORKAROUND: Place a cli before all SSYNC, CSYNC, "LCx =", "LTx =", and "LBx =" instructions to disable interrupts, and place an sti after each of these instructions to re-enable interrupts. When these instructions are executed in code that is already non-interruptible, the problem will not occur. Signed-off-by:
-
Mike Frysinger authored
Signed-off-by:
-
Mike Frysinger authored
Signed-off-by:
-
Mike Frysinger authored
Signed-off-by:
-
Mike Frysinger authored
Signed-off-by:
-
Sonic Zhang authored
Config EBIU flash mode properly. EBIU_MODE EBIU_FCTL EBIU_MBSCTL register should be configurd to Flash mode. Signed-off-by:
-
Cliff Cai authored
Signed-off-by:
Cliff Cai <cliff.cai@analog.com> Signed-off-by:
-
- 17 Nov, 2007 6 commits
-
-
Robin Getz authored
Signed-off-by:
-
Bernd Schmidt authored
Revert this patch: move the init sections to the end of memory, so that after they are free, run time memory is all continugous - this should help decrease memory fragementation. When doing this, we also pack some of the other sections a little closer together, to make sure we don't waste memory. To make this happen, we need to rename the .data.init_task section to .init_task.data, so it doesn't get picked up by the linker script glob. Since it causes the kernel not to boot up with mtd filesystems. Signed-off-by:
Bernd Schmidt <bernd.schmidt@analog.com> Signed-off-by:
-
Jie Zhang authored
Signed-off-by:
Jie Zhang <jie.zhang@analog.com> Signed-off-by:
-
Michael Hennerich authored
Signed-off-by:
-
Robin Getz authored
Signed-off-by:
-
Michael Hennerich authored
/* * CPUs often take a performance hit when accessing unaligned memory * locations. The actual performance hit varies, it can be small if the * hardware handles it or large if we have to take an exception and fix * it * in software. * * Since an ethernet header is 14 bytes network drivers often end up * with * the IP header at an unaligned offset. The IP header can be aligned by * shifting the start of the packet by 2 bytes. Drivers should do this * with: * * skb_reserve(NET_IP_ALIGN); * * The downside to this alignment of the IP header is that the DMA is * now * unaligned. On some architectures the cost of an unaligned DMA is high * and this cost outweighs the gains made by aligning the IP header. * * Since this trade off varies between architectures, we allow * NET_IP_ALIGN * to be overridden. */ This new function insl_16 allows to read form 32-bit IO and writes to 16-bit aligned memory. This is useful in above described scenario - In particular with the AXIS AX88180 Gigabit Ethernet MAC. Once the device is in 32-bit mode, reads from the RX FIFO always decrements 4bytes. While on the other side the destination address in SDRAM is always 16-bit aligned. If we use skb_reserve(0) the receive buffer is 32-bit aligned but later we hit a unaligned exception in the IP code. Signed-off-by:
-
- 23 Nov, 2007 1 commit
-
-
Mike Frysinger authored
If you need a 64 bit divide in the kernel, use asm/div64.h. Revert the addition of udivdi3. Cc: Bernd Schmidt <bernd.schmidt@analog.com> Signed-off-by:
-
- 17 Nov, 2007 4 commits
-
-
Mike Frysinger authored
Signed-off-by:
-
Adrian Bunk authored
The only user of get_wchan I was able to find is the proc fs - and proc can't be built modular. Signed-off-by:
Adrian Bunk <bunk@kernel.org> Signed-off-by:
-
Adrian Bunk authored
The only user is the a.out support. It was therefore removed prior to the blackfin merge from all architectures not supporting a.out. Currently, Blackfin doesn't suppport a.out. Signed-off-by:
-
Robert P. J. Day authored
i'm *reasonably* confident that this is a typo that should be fixed. Signed-off-by:
Robert P. J. Day <rpjday@crashcourse.ca> Signed-off-by:
-
- 15 Nov, 2007 5 commits
-
-
Michael Hennerich authored
Blackfin arch: Dont use cs_change_per_word, since the AD7877 driver doesnt require it anymore; fix bus numbers, fix typos Signed-off-by:
-
Mike Frysinger authored
Signed-off-by:
-
Mike Frysinger authored
Signed-off-by:
-
Mike Frysinger authored
Signed-off-by:
-
Mike Frysinger authored
Blackfin arch: change get_bf537_ether_addr() to bfin_get_ether_addr() since this is not BF537 specific and to better match other Blackfin-specific conventions Signed-off-by:
-
- 22 Nov, 2007 1 commit
-
-
Mike Frysinger authored
Blackfin arch: sharing the board-specific MAC function does not make sense so move it into board-specific files Signed-off-by:
-
- 15 Nov, 2007 2 commits
-
-
Mike Frysinger authored
VDSP has double fault on core a/b inverted for BF561 -- bit 11 is core a while bit 12 is core b Signed-off-by:
-
Mike Frysinger authored
since we have this always turned on now and dont want it off (and hasnt been an option in a while) Signed-off-by:
-
