- 23 Jul, 2015 40 commits
-
-
Mateusz Kulikowski authored
Use naming schema found in other rtlwifi devices. Rename PHY_SetRtl8192eRfOff to rtl92e_set_rf_off. Signed-off-by:
Mateusz Kulikowski <mateusz.kulikowski@gmail.com> Signed-off-by:
Greg Kroah-Hartman <gregkh@linuxfoundation.org>
-
Mateusz Kulikowski authored
Use naming schema found in other rtlwifi devices. Rename PHY_ScanOperationBackup8192 to rtl92e_scan_op_backup. Signed-off-by:
-
Mateusz Kulikowski authored
Use naming schema found in other rtlwifi devices. Rename InitialGain819xPci to rtl92e_init_gain. Signed-off-by:
-
Mateusz Kulikowski authored
Use naming schema found in other rtlwifi devices. Rename firmware_init_param to rtl92e_init_fw_param. Signed-off-by:
-
Mateusz Kulikowski authored
Use naming schema found in other rtlwifi devices. Rename rtl8192_update_ratr_table to rtl92e_update_ratr_table. Signed-off-by:
-
Mateusz Kulikowski authored
Use naming schema found in other rtlwifi devices. Rename rtl8192_tx_fill_desc to rtl92e_fill_tx_desc. Signed-off-by:
-
Mateusz Kulikowski authored
Use naming schema found in other rtlwifi devices. Rename rtl8192_tx_fill_cmd_desc to rtl92e_fill_tx_cmd_desc. Signed-off-by:
-
Mateusz Kulikowski authored
Use naming schema found in other rtlwifi devices. Rename rtl8192_rx_query_status_desc to rtl92e_get_rx_stats. Signed-off-by:
-
Mateusz Kulikowski authored
Use naming schema found in other rtlwifi devices. Rename rtl8192_link_change to rtl92e_link_change. Signed-off-by:
-
Mateusz Kulikowski authored
Use naming schema found in other rtlwifi devices. Rename rtl8192_interrupt_recognized to rtl92e_ack_irq. Signed-off-by:
-
Mateusz Kulikowski authored
Use naming schema found in other rtlwifi devices. Rename rtl8192_InitializeVariables to rtl92e_init_variables. Signed-off-by:
-
Mateusz Kulikowski authored
Use naming schema found in other rtlwifi devices. Rename rtl8192_HalTxCheckStuck to rtl92e_is_tx_stuck. Signed-off-by:
-
Mateusz Kulikowski authored
Use naming schema found in other rtlwifi devices. Rename rtl8192_halt_adapter to rtl92e_stop_adapter. Signed-off-by:
-
Mateusz Kulikowski authored
Use naming schema found in other rtlwifi devices. Rename rtl8192_HalRxCheckStuck to rtl92e_is_rx_stuck. Signed-off-by:
-
Mateusz Kulikowski authored
Use naming schema found in other rtlwifi devices. Rename rtl8192_GetNmodeSupportBySecCfg to rtl92e_get_nmode_support_by_sec. Signed-off-by:
-
Mateusz Kulikowski authored
Use naming schema found in other rtlwifi devices. Rename rtl8192_GetHalfNmodeSupportByAPs to rtl92e_is_halfn_supported_by_ap. Signed-off-by:
-
Mateusz Kulikowski authored
Use naming schema found in other rtlwifi devices. Rename rtl8192_get_eeprom_size to rtl92e_get_eeprom_size. Signed-off-by:
-
Mateusz Kulikowski authored
Use naming schema found in other rtlwifi devices. Rename rtl8192e_start_beacon to rtl92e_start_beacon. Signed-off-by:
-
Mateusz Kulikowski authored
Use naming schema found in other rtlwifi devices. Rename rtl8192e_SetHwReg to rtl92e_set_reg. Signed-off-by:
-
Mateusz Kulikowski authored
Use naming schema found in other rtlwifi devices. Rename rtl8192_enable_tx to rtl92e_enable_tx. Signed-off-by:
-
Mateusz Kulikowski authored
Use naming schema found in other rtlwifi devices. Rename rtl8192_enable_rx to rtl92e_enable_rx. Signed-off-by:
-
Mateusz Kulikowski authored
Use naming schema found in other rtlwifi devices. Rename rtl8192_EnableInterrupt to rtl92e_enable_irq. Signed-off-by:
-
Mateusz Kulikowski authored
Use naming schema found in other rtlwifi devices. Rename rtl8192_DisableInterrupt to rtl92e_disable_irq. Signed-off-by:
-
Mateusz Kulikowski authored
Use naming schema found in other rtlwifi devices. Rename rtl8192_ClearInterrupt to rtl92e_clear_irq. Signed-off-by:
-
Mateusz Kulikowski authored
Use naming schema found in other rtlwifi devices. Rename rtl8192_AllowAllDestAddr to rtl92e_set_monitor_mode. Signed-off-by:
-
Mateusz Kulikowski authored
Use naming schema found in other rtlwifi devices. Rename rtl8192_adapter_start to rtl92e_start_adapter. Signed-off-by:
-
Mateusz Kulikowski authored
Use naming schema found in other rtlwifi devices. Rename cmpk_message_handle_tx to rtl92e_send_cmd_pkt. Signed-off-by:
-
Mateusz Kulikowski authored
Use naming schema found in other rtlwifi devices. Rename PHY_SetRF8256OFDMTxPower to rtl92e_set_ofdm_tx_power. Signed-off-by:
-
Mateusz Kulikowski authored
Use naming schema found in other rtlwifi devices. Rename PHY_SetRF8256CCKTxPower to rtl92e_set_cck_tx_power. Signed-off-by:
-
Mateusz Kulikowski authored
Use naming schema found in other rtlwifi devices. Rename PHY_SetRF8256Bandwidth to rtl92e_set_bandwidth. Signed-off-by:
-
Mateusz Kulikowski authored
Use naming schema found in other rtlwifi devices. Rename PHY_RF8256_Config to rtl92e_config_rf. Signed-off-by:
-
Neil Horman authored
The netdev we're testing for can't be removed, because its never unregistered, so don't bother checking for it Signed-off-by:
Neil Horman <nhorman@redhat.com> Signed-off-by:
Benjamin Romer <benjamin.romer@unisys.com> Signed-off-by:
-
Neil Horman authored
All it does is return no supported. Removing the function entirely accomplishes the same thing Signed-off-by:
-
Neil Horman authored
dev_trans_start does this for us now Signed-off-by:
-
Neil Horman authored
Using NETDEV_TX_BUSY is tricky. Its meant for situations where the error in question is transient and quickly resolved. But the driver rarely is able to know that to a certainty. And in the case of visornic, it just uses it without any care for that, in the hopes that it won't loose frames, even if the problem is that the skb is somehow malformed for the hardware. If we get one of those kinds of skbs, NETDEV_TX_BUSY will just cause us to spin, processing the same error over and over. Fix it by dropping the frame, stopping the queue where appropriate, and returning NETDEV_TX_OK Signed-off-by:
-
Neil Horman authored
If we put them in the enable and disable paths, we don't need them in several other places Signed-off-by:
-
Neil Horman authored
I don't see why the server should stop responding, or that we should just give up if it does. Wait forever when enabling/disabling the visornic Signed-off-by:
-
Neil Horman authored
I don't see why serverdown should be async on a workqueue. Just make it synchronous, and remove some code in the process Signed-off-by:
-
Neil Horman authored
Theres a lot of code duplication going on in visornic_serverdown_complete. We should just be able to send it through the dev_close path and have it do the right things. Signed-off-by:
-
Neil Horman authored
Its possible to overwrite the old task pointer in visornic_resume. Add a check to guard against that and a warning if we find that its already running Signed-off-by:
-
