No generated code change.
Signed-off-by: Nicholas Piggin <npiggin@gmail.com>
Signed-off-by: Michael Ellerman <mpe@ellerman.id.au>

Restore all SPRs and CR up-front, these are longer latency
instructions. Move register restore around to maximise pairs of
adjacent loads (e.g., restore r0 next to r1).
Signed-off-by: Nicholas Piggin <npiggin@gmail.com>
Signed-off-by: Michael Ellerman <mpe@ellerman.id.au>

Duplicate the hmi windup code for both cases, rather than to put a
special case branch in the middle of it. Remove unused label. This
helps with later code consolidation.
Signed-off-by: Nicholas Piggin <npiggin@gmail.com>
Signed-off-by: Michael Ellerman <mpe@ellerman.id.au>

Move in_mce decrement earlier before registers are restored (but
still after RI=0). This helps with later consolidation.
Signed-off-by: Nicholas Piggin <npiggin@gmail.com>
Signed-off-by: Michael Ellerman <mpe@ellerman.id.au>

Trivial code change, r3->r9.
Signed-off-by: Nicholas Piggin <npiggin@gmail.com>
Signed-off-by: Michael Ellerman <mpe@ellerman.id.au>

All supported 64s CPUs support mtmsrd L=1 instruction, so a cleanup
can be made in sreset and mce handlers.
Signed-off-by: Nicholas Piggin <npiggin@gmail.com>
Signed-off-by: Michael Ellerman <mpe@ellerman.id.au>

Move SPR reads ahead of writes. Real mode entry that is not a KVM
guest is rare these days, but bad practice propagates.
Signed-off-by: Nicholas Piggin <npiggin@gmail.com>
Signed-off-by: Michael Ellerman <mpe@ellerman.id.au>

syscall / hcall entry unnecessarily differs between KVM and non-KVM
builds. Move the SMT priority instruction to the same location
(after INTERRUPT_TO_KERNEL).
Signed-off-by: Nicholas Piggin <npiggin@gmail.com>
Signed-off-by: Michael Ellerman <mpe@ellerman.id.au>

No generated code change.
Signed-off-by: Nicholas Piggin <npiggin@gmail.com>
Signed-off-by: Michael Ellerman <mpe@ellerman.id.au>

No generated code change. Final vmlinux is changed only due to change
in bug table line numbers.
Signed-off-by: Nicholas Piggin <npiggin@gmail.com>
Signed-off-by: Michael Ellerman <mpe@ellerman.id.au>

No generated code change.
Signed-off-by: Nicholas Piggin <npiggin@gmail.com>
Signed-off-by: Michael Ellerman <mpe@ellerman.id.au>

Generally, macros that result in instructions being expanded are
indented by a tab, and those that don't have no indent. Fix the
obvious cases that go contrary to style.

No generated code change.
Signed-off-by: Nicholas Piggin <npiggin@gmail.com>
Signed-off-by: Michael Ellerman <mpe@ellerman.id.au>

No generated code change.
Signed-off-by: Nicholas Piggin <npiggin@gmail.com>
Signed-off-by: Michael Ellerman <mpe@ellerman.id.au>

Signed-off-by: Nicholas Piggin <npiggin@gmail.com>
Signed-off-by: Michael Ellerman <mpe@ellerman.id.au>

No generated code change.
Signed-off-by: Nicholas Piggin <npiggin@gmail.com>
Signed-off-by: Michael Ellerman <mpe@ellerman.id.au>

No generated code change.
Signed-off-by: Nicholas Piggin <npiggin@gmail.com>
Signed-off-by: Michael Ellerman <mpe@ellerman.id.au>

No generated code change.
Signed-off-by: Nicholas Piggin <npiggin@gmail.com>
Signed-off-by: Michael Ellerman <mpe@ellerman.id.au>

No generated code change.
Signed-off-by: Nicholas Piggin <npiggin@gmail.com>
Signed-off-by: Michael Ellerman <mpe@ellerman.id.au>

These are only called in one place each.

No generated code change.
Signed-off-by: Nicholas Piggin <npiggin@gmail.com>
Signed-off-by: Michael Ellerman <mpe@ellerman.id.au>

No generated code change.
Signed-off-by: Nicholas Piggin <npiggin@gmail.com>
Signed-off-by: Michael Ellerman <mpe@ellerman.id.au>

After the previous cleanup, it becomes possible to consolidate some
common code outside the runtime alternate patching. Also remove
unused labels.

This results in some code change, but unchanged runtime instruction
sequence.
Signed-off-by: Nicholas Piggin <npiggin@gmail.com>
Signed-off-by: Michael Ellerman <mpe@ellerman.id.au>

Many of these macros just specify 1-4 lines which are only called a
few times each at most, and often just once. Remove this indirection.

No generated code change.
Signed-off-by: Nicholas Piggin <npiggin@gmail.com>
Signed-off-by: Michael Ellerman <mpe@ellerman.id.au>

More cases of code insertion via macros that does not add a great
deal. All the additions have to be specified in the macro arguments,
so they can just as well go after the macro.

No generated code change.
Signed-off-by: Nicholas Piggin <npiggin@gmail.com>
Signed-off-by: Michael Ellerman <mpe@ellerman.id.au>

The aim is to reduce the amount of indirection it takes to get through
the exception handler macros, particularly where it provides little
code sharing.

No generated code change.
Signed-off-by: Nicholas Piggin <npiggin@gmail.com>
Signed-off-by: Michael Ellerman <mpe@ellerman.id.au>

No generated code change.
Signed-off-by: Nicholas Piggin <npiggin@gmail.com>
Signed-off-by: Michael Ellerman <mpe@ellerman.id.au>

Move the KVM trap HSRR bit into the KVM handler, which can be
conditionally applied when hsrr parameter is set.

No generated code change.
Signed-off-by: Nicholas Piggin <npiggin@gmail.com>
Signed-off-by: Michael Ellerman <mpe@ellerman.id.au>

Conditionally expand the skip case if it is specified.

No generated code change.
Signed-off-by: Nicholas Piggin <npiggin@gmail.com>
Signed-off-by: Michael Ellerman <mpe@ellerman.id.au>

Conditionally expand the soft-masking test if a mask is passed in.

No generated code change.
Signed-off-by: Nicholas Piggin <npiggin@gmail.com>
Signed-off-by: Michael Ellerman <mpe@ellerman.id.au>

Rather than pass in the soft-masking and KVM tests via macro that is
passed to another macro to expand it, switch to usig gas macros and
conditionally expand the soft-masking and KVM tests.

The system reset with its idle test is open coded as it is a one-off.

No generated code change.
Signed-off-by: Nicholas Piggin <npiggin@gmail.com>
Signed-off-by: Michael Ellerman <mpe@ellerman.id.au>

The sreset handler KVM test theoretically should not depend on P7.
In practice KVM now only supports P7 and up so no real bug fix, but
this change is made now so the quirk is not propagated through
cleanup patches.
Signed-off-by: Nicholas Piggin <npiggin@gmail.com>
Signed-off-by: Michael Ellerman <mpe@ellerman.id.au>

- Re-name the macros to _REAL and _VIRT suffixes rather than no and
  _RELON suffix.

- Move the macro definitions together in the file.

- Move RELOCATABLE ifdef inside the _VIRT macro.

Further consolidation between variants does not buy much here.

No generated code change.
Signed-off-by: Nicholas Piggin <npiggin@gmail.com>
Signed-off-by: Michael Ellerman <mpe@ellerman.id.au>

Switch to a gas macro that conditionally expands the RI clearing
instruction.

No generated code change.
Signed-off-by: Nicholas Piggin <npiggin@gmail.com>
Signed-off-by: Michael Ellerman <mpe@ellerman.id.au>

Replace all instances of this with gas macros that test the hsrr
parameter and use the appropriate register names / labels.

No generated code change.
Signed-off-by: Nicholas Piggin <npiggin@gmail.com>
[mpe: Remove extraneous 2nd check for 0xea0 in SOFTEN_TEST]
Signed-off-by: Michael Ellerman <mpe@ellerman.id.au>

Remove SOFTEN_VALUE_0x980, it's been unused since commit
dabe859e ("powerpc: Give hypervisor decrementer interrupts their
own handler") (Sep 2012).
Signed-off-by: Michael Ellerman <mpe@ellerman.id.au>

By convention, all lines should be separated by a semicolons. Last line
should have neither semicolon or line wrap.

No generated code change.
Signed-off-by: Nicholas Piggin <npiggin@gmail.com>
Signed-off-by: Michael Ellerman <mpe@ellerman.id.au>

These two function have never been used anywhere in the kernel tree
since they were added to the kernel.
Signed-off-by: Christoph Hellwig <hch@lst.de>
Signed-off-by: Michael Ellerman <mpe@ellerman.id.au>

None of these routines were ever used anywhere in the kernel tree
since they were added to the kernel.
Signed-off-by: Christoph Hellwig <hch@lst.de>
Signed-off-by: Michael Ellerman <mpe@ellerman.id.au>

These have been unused anywhere in the kernel tree ever since they've
been added to the kernel.
Signed-off-by: Christoph Hellwig <hch@lst.de>
Signed-off-by: Michael Ellerman <mpe@ellerman.id.au>

This function has never been used anywhere in the kernel tree since it
was added to the tree.  We also now have proper PCIe P2P APIs in the core
kernel, and any new P2P support should be using those.
Signed-off-by: Christoph Hellwig <hch@lst.de>
Signed-off-by: Michael Ellerman <mpe@ellerman.id.au>

Commit ed49f7fd ("powerpc/xmon: Disable tracing when entering
xmon") added code to disable recording trace entries while in xmon. The
commit introduced a variable 'tracing_enabled' to record if tracing was
enabled on xmon entry, and used this to conditionally enable tracing
during exit from xmon.

However, we are not checking the value of 'fromipi' variable in
xmon_core() when setting 'tracing_enabled'. Due to this, when secondary
cpus enter xmon, they will see tracing as being disabled already and
tracing won't be re-enabled on exit. Fix the same.

Fixes: ed49f7fd ("powerpc/xmon: Disable tracing when entering xmon")
Signed-off-by: Naveen N. Rao <naveen.n.rao@linux.vnet.ibm.com>
Signed-off-by: Michael Ellerman <mpe@ellerman.id.au>