- 21 Mar, 2006 40 commits
-
-
Arnaldo Carvalho de Melo authored
Testing if the ccid being instantiated has these methods in ccid_init(). Signed-off-by:
Arnaldo Carvalho de Melo <acme@mandriva.com> Signed-off-by:
David S. Miller <davem@davemloft.net>
-
Andrea Bittau authored
Based on a patch by Andrea Bittau. Signed-off-by:
Andrea Bittau <a.bittau@cs.ucl.ac.uk> Signed-off-by:
-
Arnaldo Carvalho de Melo authored
For iterating over list of given type continuing from existing point. Signed-off-by:
-
Robert Olsson authored
Signed-off-by:
Robert Olsson <robert.olsson@its.uu.se> Signed-off-by:
-
Arnaldo Carvalho de Melo authored
For iterate over list of given type from existing point safe against removal of list entry. Signed-off-by:
-
Arnaldo Carvalho de Melo authored
Signed-off-by:
-
Arnaldo Carvalho de Melo authored
Signed-off-by:
-
Arnaldo Carvalho de Melo authored
Simplifying the code a bit as we're always using DCCP_MAX_ACKVEC_LEN. Signed-off-by:
-
Harald Welte authored
By using a sequence number for every logged netfilter event, we can determine from userspace whether logging information was lots somewhere downstream. The user has a choice of either having per-instance local sequence counters, or using a global sequence counter, or both. Signed-off-by:
Harald Welte <laforge@netfilter.org> Signed-off-by:
-
Harald Welte authored
This patch reduces the size of 'struct ip_conntrack' on systems with NAT by eight bytes. The sequence number delta values can be int16_t, since we only support one sequence number modification per window anyway, and one such modification is not going to exceed 32kB ;) Signed-off-by:
-
David S. Miller authored
Try to allocate the struct file and an unused file descriptor before we try to pull a newly accepted socket out of the protocol layer. Based upon a patch by Prassana Meda. Signed-off-by: -
Patrick McHardy authored
Move skb->nf_mark next to skb->tc_index to remove a 4 byte hole between skb->nfmark and skb->nfct and another one between skb->users and skb->head when CONFIG_NETFILTER, CONFIG_NET_SCHED and CONFIG_NET_CLS_ACT are enabled. For all other combinations the size stays the same. Signed-off-by:
Patrick McHardy <kaber@trash.net> Signed-off-by:
-
Stefan Rompf authored
this patch adds support to the VLAN driver to translate IF_OPER_DORMANT of the underlying device to netif_dormant_on(). Beside clean state forwarding, this allows running independant userspace supplicants on both the real device and the stacked VLAN. It depends on my RFC2863 patch. Signed-off-by:
Stefan Rompf <stefan@loplof.de> Signed-off-by:
-
Stefan Rompf authored
this patch adds a dormant flag to network devices, RFC2863 operstate derived from these flags and possibility for userspace interaction. It allows drivers to signal that a device is unusable for user traffic without disabling queueing (and therefore the possibility for protocol establishment traffic to flow) and a userspace supplicant (WPA, 802.1X) to mark a device unusable without changes to the driver. It is the result of our long discussion. However I must admit that it represents what Jamal and I agreed on with compromises towards Krzysztof, but Thomas and Krzysztof still disagree with some parts. Anyway I think it should be applied. Signed-off-by:
-
YOSHIFUJI Hideaki authored
It is possible to get redirects from nexthop of "more-specific" routes. Signed-off-by:
YOSHIFUJI Hideaki <yoshfuji@linux-ipv6.org> Signed-off-by:
-
YOSHIFUJI Hideaki authored
Signed-off-by:
-
YOSHIFUJI Hideaki authored
Signed-off-by:
-
YOSHIFUJI Hideaki authored
Signed-off-by:
-
YOSHIFUJI Hideaki authored
Signed-off-by:
-
YOSHIFUJI Hideaki authored
Signed-off-by:
-
YOSHIFUJI Hideaki authored
Signed-off-by:
-
YOSHIFUJI Hideaki authored
Signed-off-by:
-
YOSHIFUJI Hideaki authored
Signed-off-by:
-
YOSHIFUJI Hideaki authored
Signed-off-by:
-
YOSHIFUJI Hideaki authored
Signed-off-by:
-
YOSHIFUJI Hideaki authored
Signed-off-by:
-
YOSHIFUJI Hideaki authored
Check RTF_ADDRCONF|RTF_DEFAULT in rt6_get_dflt_router(). Signed-off-by:
-
YOSHIFUJI Hideaki authored
And prepare for more advanced router selection. Signed-off-by:
-
YOSHIFUJI Hideaki authored
Signed-off-by:
-
YOSHIFUJI Hideaki authored
Signed-off-by:
-
YOSHIFUJI Hideaki authored
Signed-off-by:
-
YOSHIFUJI Hideaki authored
Signed-off-by:
-
YOSHIFUJI Hideaki authored
Signed-off-by:
-
YOSHIFUJI Hideaki authored
Signed-off-by:
-
YOSHIFUJI Hideaki authored
Signed-off-by:
-
YOSHIFUJI Hideaki authored
Signed-off-by:
-
YOSHIFUJI Hideaki authored
This controls whether we accept Prefix Information in RAs. Signed-off-by:
-
YOSHIFUJI Hideaki authored
This controls whether we accept default router information in RAs. Signed-off-by:
-
YOSHIFUJI Hideaki authored
Signed-off-by:
-
YOSHIFUJI Hideaki authored
RFC 3041 describes an algorithm to generate random interface identifier. In RFC 3041bis, it is allowed to use different algorithm than one described in RFC 3041. So, let's use our standard pseudo random algorithm to simplify our implementation. Signed-off-by:
-
