Signed-off-by: Yoichi Yuasa <yoichi_yuasa@tripeaks.co.jp>
Signed-off-by: Ralf Baechle <ralf@linux-mips.org>

Signed-off-by: Yoichi Yuasa <yoichi_yuasa@tripeaks.co.jp>
Signed-off-by: Ralf Baechle <ralf@linux-mips.org>

Signed-off-by: Yoichi Yuasa <yoichi_yuasa@tripeaks.co.jp>
Signed-off-by: Ralf Baechle <ralf@linux-mips.org>

Signed-off-by: Yoichi Yuasa <yoichi_yuasa@tripeaks.co.jp>
Signed-off-by: Ralf Baechle <ralf@linux-mips.org>

Signed-off-by: Atsushi Nemoto <anemo@mba.ocn.ne.jp>
Signed-off-by: Ralf Baechle <ralf@linux-mips.org>

Leaving these sections is useful to some tools that look at the image, and
none of them are loaded into memory.  The .mdebug.abi64 section, in
particular, lets GDB recognize vmlinux.32 as an N64 program instead of
guessing that it is O32.
Signed-off-by: Daniel Jacobowitz <dan@codesourcery.com>
Signed-off-by: Ralf Baechle <ralf@linux-mips.org>

Update defconfigs, disabling CONFIG_EXPERIMENTAL.
Signed-off-by: Atsushi Nemoto <anemo@mba.ocn.ne.jp>
Signed-off-by: Ralf Baechle <ralf@linux-mips.org>

Now these directories can be built cleanly.
Signed-off-by: Atsushi Nemoto <anemo@mba.ocn.ne.jp>
Signed-off-by: Ralf Baechle <ralf@linux-mips.org>

Signed-off-by: Atsushi Nemoto <anemo@mba.ocn.ne.jp>
Signed-off-by: Ralf Baechle <ralf@linux-mips.org>

Cleanup jmr3927, tx4927 and tx4938 irq codes, using common IRQ_CPU,
I8259 and IRQ_TXX9 irq routines.
Signed-off-by: Atsushi Nemoto <anemo@mba.ocn.ne.jp>
Signed-off-by: Ralf Baechle <ralf@linux-mips.org>

Add generic irq_chip for TX39/TX49 SoCs.  This can be replace
jmr3927_irq_irc, tx4927_irq_pic_type and tx4938_irq_pic_type.
Signed-off-by: Atsushi Nemoto <anemo@mba.ocn.ne.jp>
Signed-off-by: Ralf Baechle <ralf@linux-mips.org>

This is needed since the Sibyte serial driver was exchanged.

Issue report by Imre Kaloz <kaloz@openwrt.org>.
Signed-off-by: Ralf Baechle <ralf@linux-mips.org>

Signed-off-by: Yoichi Yuasa <yoichi_yuasa@tripeaks.co.jp>
Signed-off-by: Ralf Baechle <ralf@linux-mips.org>

Signed-off-by: Yoichi Yuasa <yoichi_yuasa@tripeaks.co.jp>
Signed-off-by: Ralf Baechle <ralf@linux-mips.org>

The user should not have to have any clue about this setting.
Signed-off-by: Ralf Baechle <ralf@linux-mips.org>

Signed-off-by: Ralf Baechle <ralf@linux-mips.org>

Signed-off-by: Ralf Baechle <ralf@linux-mips.org>

For debugging purposes only.
Signed-off-by: Ralf Baechle <ralf@linux-mips.org>

For the generation of asm-offset.h to work these need to be evaulatable
by gcc as a constant expression.  This issue did exist for a while but
didn't bite because they're only in asm-offset.h for debugging purposes.
Signed-off-by: Ralf Baechle <ralf@linux-mips.org>

Signed-off-by: Ralf Baechle <ralf@linux-mips.org>

runtime limit and wakeup granularity used to be a function of
granularity and that was incorrect changed to sched_latency.

Fix this to make wakeup granularity a function of min-granularity,
and the runtime limit equal to latency.
Signed-off-by: Ingo Molnar <mingo@elte.hu>

* git://git.kernel.org/pub/scm/linux/kernel/git/mingo/linux-2.6-sched:
  sched: cleanup, sched_granularity -> sched_min_granularity
  sched: adaptive scheduler granularity
  sched: fix CONFIG_SCHED_DEBUG dependency of lockdep sysctls

* 'for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/ieee1394/linux1394-2.6:
  firewire: Add ref-counting for sbp2 orbs (fix command abortion)
  firewire: fix unloading of fw-ohci while devices are attached
  ieee1394: sbp2: fix sbp2_remove_device for error cases

due to adaptive granularity scheduling the role of sched_granularity
has changed to "minimum granularity", so rename the variable (and the
tunable) accordingly.
Signed-off-by: Ingo Molnar <mingo@elte.hu>
Signed-off-by: Peter Zijlstra <a.p.zijlstra@chello.nl>

Instead of specifying the preemption granularity, specify the wanted
latency. By fixing the granlarity to a constany the wakeup latency
it a function of the number of running tasks on the rq.

Invert this relation.

sysctl_sched_granularity becomes a minimum for the dynamic granularity
computed from the new sysctl_sched_latency.

Then use this latency to do more intelligent granularity decisions: if
there are fewer tasks running then we can schedule coarser. This helps
performance while still always keeping the latency target.
Signed-off-by: Peter Zijlstra <a.p.zijlstra@chello.nl>
Signed-off-by: Ingo Molnar <mingo@elte.hu>

Make the lockdep sysctls not depend on CONFIG_SCHED_DEBUG.
Signed-off-by: Peter Zijlstra <a.p.zijlstra@chello.nl>
Signed-off-by: Ingo Molnar <mingo@elte.hu>

This handles the case where we get the status write before getting the
complete_transaction callback ("status write for unknown orb").  In
this case, we just assume that the initial orb pointer transaction
succeeded and finish the orb.  To prevent the transaction callback
from touching freed memory, we ref-count the orb structures.
Signed-off-by: Kristian Høgsberg <krh@redhat.com>
Signed-off-by: Stefan Richter <stefanr@s5r6.in-berlin.de>

Fix panic in run_timer_softirq right after "modprobe -r firewire-ohci"
if a FireWire disk was attached and firewire-sbp2 loaded.
Signed-off-by: Stefan Richter <stefanr@s5r6.in-berlin.de>

Bug found by Olaf Hering <olh@suse.de>:
sbp2util_remove_command_orb_pool requires a valid lu->hi pointer.
Signed-off-by: Stefan Richter <stefanr@s5r6.in-berlin.de>

* 'agp-patches' of git://git.kernel.org/pub/scm/linux/kernel/git/airlied/agp-2.6:
  agp: balance ioremap checks
  agp: Add device id for P4M900 to via-agp module
  efficeon-agp leaks 'struct agp_bridge_data' in error paths of agp_efficeon_probe()

* 'drm-patches' of git://git.kernel.org/pub/scm/linux/kernel/git/airlied/drm-2.6:
  drm: ioremap return value checks
  drm/via: Fix dmablit when blit queue is full
  drm_rmmap_ioctl(): remove dead code

* 'upstream-linus' of master.kernel.org:/pub/scm/linux/kernel/git/jgarzik/netdev-2.6:
  myri10ge: update driver version to 1.3.2-1.269
  myri10ge: use pcie_get/set_readrq
  ehea: fix queue destructor
  ehea: fix module parameter description
  ehea: fix interface to DLPAR tools
  sgiseeq: Fix return type of sgiseeq_remove
  sky2 1.17
  sky2: only bring up watchdog if link is active
  sky2: clear PCI power control reg at startup
  DM9000: fix interface hang under load
  phy layer: fix genphy_setup_forced (don't reset)
  Don't use GFP_DMA for zone allocation.
  fix realtek phy id in forcedeth

* 'release' of git://git.kernel.org/pub/scm/linux/kernel/git/lenb/linux-acpi-2.6: (30 commits)
  ACPI: work around duplicate name "VID" problem on T61
  acpiphp_ibm: add missing '\n' to error message
  ACPI: add dump_stack() to trace acpi_format_exception programming errors
  make drivers/acpi/scan.c:create_modalias() static
  ACPI: Fix a warning of discarding qualifiers from pointer target type
  ACPI: "ACPI handle has no context!" should be KERN_DEBUG
  ACPI video hotkey: export missing ACPI video hotkey events via input layer
  ACPI: Validate XSDT, use RSDT if XSDT fails
  ACPI: /proc/acpi/thermal_zone trip points are now read-only, mark them as such
  ACPI: fix ia64 allnoconfig build
  PNP: remove null pointer checks
  PNP: remove MODULE infrastructure
  ISAPNP: removed unused isapnp_detected and ISAPNP_DEBUG
  PNPACPI: remove unnecessary casts of "void *"
  PNPACPI: simplify irq_flags()
  PNP: fix up after Lindent
  ACPI: enable GPEs before calling _WAK on resume
  asus-laptop: Fix rmmod of asus_laptop
  sony-laptop: call sonypi_compat_init earlier
  sony-laptop: enable Vaio FZ events
  ...

Signed-off-by: Scott Thompson <postfail <at> hushmail.com>
Signed-off-by: Dave Airlie <airlied@linux.ie>

patchset against 2.6.23-rc3.
corrects missing ioremap return checks and balancing on iounmap calls, integrated changes per list
recommendations on the original set of patches..

Signed-off-by: Scott Thompson <postfail <at> hushmail.com>
Signed-off-by: Dave Airlie <airlied@linux.ie>

Signed-off-by: Dave Airlie <airlied@linux.ie>

Update myri10ge driver version to 1.3.2-1.269.
Signed-off-by: Brice Goglin <brice@myri.com>
Signed-off-by: Jeff Garzik <jeff@garzik.org>

Based on a patch from Peter Oruba, convert myri10ge to use pcie_get_readrq()
and pcie_set_readrq() instead of our own PCI calls and arithmetics.

These driver changes incorporate the proposed PCI-X / PCI-Express read byte
count interface.  Reading and setting those values doesn't take place
"manually", instead wrapping functions are called to allow quirks for some
PCI bridges.
Signed-off-by: Brice Goglin <brice@myri.com>
Signed-off by: Peter Oruba <peter.oruba@amd.com>
Based on work by Stephen Hemminger <shemminger@linux-foundation.org>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Jeff Garzik <jeff@garzik.org>

Includes hcp_epas_dtor in eq/cq/qp destructors to unmap
HW register.
Signed-off-by: Jan-Bernd Themann <themann@de.ibm.com>
Signed-off-by: Jeff Garzik <jeff@garzik.org>

Update the module parameter description of "use_mcs" to
show correct default value
Signed-off-by: Jan-Bernd Themann <themann@de.ibm.com>
Signed-off-by: Jeff Garzik <jeff@garzik.org>